Mayline E-Series User Manual
(1)
ASSEMBLY INSTRUCTIONS
for 'E' Series VariTask
NOTE: Install base so Power Plug
is easily accessible
NOTE: Bases shown with optional trim panel
NOTE: Please count and inspect all pieces before disposing of any carton or packing materials.
COMPONENTS:
REF. # QTY. DESCRIPTION PART No.
1 1 BASE ASSEMBLY CALL**
2 1 COLUMN ASSEMBLY A7641**
3 1 TOP PLATE B7052
HARDWARE BAG (PART No. A7642)
REF. # QTY DESCRIPTION PART No.
E1 1 SWITCH w/ Screws Z480*
E2 4 GLIDE Q607*
E3 4 1/4"-20 x 1 3/4" HEX SCREW D38*
E4 8 1/4" LOCK WASHER W29*
E5 4 1/4"-28 x 1/2" HEX SCREW X314*
When ordering components, specific color and/or size information may be required.
Contact a Mayline Customer Service Representative. 1-800-822-8037
*for individual item, order that part number
The following hardware is included for the proper attachment of a
Work Surface and for cable management:
** Denotes Color Code
E6 1 1/8" CABLE CLAMP F690*
E7 1 3/16" CABLE CLAMP F600*
E8 2 3/8" CABLE CLAMP F189*
E9 4 #10 x 3/4" SCREW X11*
E10 6 #10 x 1" SCREW X12*
Glide (E2)
(2)
FRONT
Column (2)
Hex Head Screw (E3)
Lock Washer (E4)
MOUNTING BASE LEGS to COLUMN
1. Place Column Assembly (2) on end with Power Cord up.
2. Turn the Base Legs (1) upside-down and position the
front of the base legs toward the front of the column.
3. Carefully feed Power Cord through center opening in the
base and through center opening in bottom.
4. Position large opening in base over column and lower
into place. NOTE: Do Not pinch Power Cord.
Base Legs (1)
5. Fasten base with four 1/4-20 x 1 3/4 Hex Head Screw (E3)
and four 1/4 Lock Washer (E4).
6. Install Glides (E2) into Base Legs.
Top Plate (3)
MOUNTING TOP PLATE to COLUMN
7. Turn Column/Base upright and install Top Plate (3).
8. Place Top Plate (3) in a front biased position. (See
"Position of Top Plate" next page) Secure with four 1/4-28
x
1/2 Screws (E5) and four 1/4 Lock Washers (E4).
9. Connect Switch Assembly (E1) to Wiring Harness
extending from the Column side.
Switch Assembly (E1)
Loading...