Mayline CSII User Manual

ASSEMBLY INSTRUCTIONS

CATALOG No:

C583 C593 C603 C613

NOTE: Please count and inspect all pieces before disposing of any carton or packing materials.

COMPONENTS:

REF. # QTY. DESCRIPTION PART No.

1 1 WORK SURFACE CALL~~** 2 2 MODESTY PANEL CALL~~** 3 1 LEG C733** 4 2 LEG (extra mounting holes) C734** 5 2 JOINING PLATE B7522

When ordering components, specific color and/or size information may be required. Contact a Mayline Customer Service Representative. 1-800-822-8037

CORNER DESK

CATALOG No:

C542 C552 C562 C572

** Denotes Color Code ~~Denotes Size

HARDWARE BAG (PART No. A7636)

REF. # QTY DESCRIPTION PART No.

E1 26 #10 X 3/4 SCREW X11*

E2 12 #10-24- X 3/8 SCREW X147*

E3 12 #10-24 KEPS NUT T2*

E4 4 CABLE CLAMP F191*

E5 6 GLIDE Q444*

*for individual part, order that part number

(1)

NOTE: Shape, size, and accessories may vary but assembly procedure remains the same. The legs included in this assembly are similar in appearence. Identify the two legs with extra mounting holes prior to beginning the assembly.

1. Place the Work Surface (1) face down onto a clean, protected surface.

2. Place Leg (3) in the corner of the Work Surface. NOTE: This is the Leg "without" the extra mounting holes. Position this Leg approximately 3/16 from the edges and align the holes in the Leg with the pre-drilled holes in the Work Surface. Attach the Leg with six Screws (E1). DO NOT tighten screws at this time.

3. Place Legs (4) at the edge of the Work Surface. Notice the position of the extra holes on the side of these Legs. These holes will be used to join the Corner Desk to the adjacent tables. Position these Legs approximately 3/16

from the edges and align the holes in the Legs with the pre-drilled holes in the Work Surface. Attach each Leg with

six Screws (E1). DO NOT tighten screws at this time.

4. Attach the Modesty Panels (2) to each Leg with three Screws (E2) and three KEPS Nuts (E3) per end.

5. Tighten all screws at this time.

6. Install two Glides (E5) into each Leg.

7. Place the assembled Corner Desk in the upright position. MAYLINE recommends that a minimum of two people perform this task.

8. Place the Corner Desk and the adjacent tables at the location where the final assembly will be used. MAYLINE recommends that a minimum of two people perform these tasks.

9. Level the entire assembly by adjusting all of the glides.

10. Four Cable Clamps (E4) are included to position cables away from work area. Attach the clamps to the Work Surface with one Screw (E1) per clamp.

(2)

+ 2 hidden pages