Page 1
re l
o
ffice
PARTS LIST
Aberdeen Series
TM
Conference Table 144" x 48"
Model No. ACTB12
Name Part
A
REALS004
Wood Dowel
B
REALS003
Cam Post
Qty.
HB
14
HB
24
HB
C 24 2
REALS001
Cam Fastener
HB
Spare
Qty
1
2
F
H
PartName
REALS099
Grommet
REALS167
Plate
REALS118
Center Plate
HB
HB
Qty.
2
2G
1
Spare
Qty
ASSEMBLY INSTRUCTIONS
CALL 1-800-822-8037 FOR ASSISTANCE
P/N ACTB12 REV 08 07/22/14
www.mayline.com
D
REALS102**
E
Cam Sticker
REALS067
Leveler
HB
224
4
J
REALS043
M6 x 15mm
ACBT10HB
Items with HB are in
24 2
hardware box
1
Page 2
Name Part
PARTS LIST
Qty.
DO NOT assemble table with top to floor. Table must be assembled in
1
an upright position only.
Insert Wood Dowels (A) and Cams (C) into Center Panel (M). Install
2
PartName
Qty.
Cam Posts (B) into threaded inserts in Modesty Panels (P). Secure
Modesty Panels (P) to Center Panel (M) by turning Cams (C).
L
ABT12**
Top
M
ACM12**
Center Panel
IMPORTANT!
Review ALL instructions before beginning assembly. These
instructions are provided to avoid problems that may occur from
improper assembly or installation. Mayline and/or its distributor
are not responsible for failure resulting from improper assembly
or installation of this product. Moreover, all warranties are void
for failure to follow these assembly instructions.
2
1
N
P
2
ACLG**
Table Leg
2
ACM12**
Modesty Panel
P
A
B
M
C
P
M
B
P
C
Items with HB are in the hardware box
**Denotes Color Code
2
A
NOTE: The arrow on the face of the Cam (C)
should point towards the Cam Post (B) for
proper alignment.
3
Page 3
Insert Wood Dowels (A) into top edge of each Modesty Panel (P). Insert
3
Wood Dowels (A) and Cams (C) into the end of each Modesty Panel
(P). Install Cam Posts (B) into threaded inserts in Table Legs (N).
Install Leveler (E) and insert Cams (C) into the Table Legs (N). Secure
Modesty Panels (P) to Table Legs (N) by turning Cams (C).
C
Install Cam Posts (B) into threaded inserts into the underside of each
4
Top (L). Attach Plates (H & G) to the underside of Top (L) using
Screws (J).
M
P
N
E
NOTE: The arrow on the face of the Cam (C)
should point towards the Cam Post (B) for
proper alignment.
P
C
P
A
B
N
N
G
B
L
4
5
Page 4
Place each Top (L) onto the base. Fasten tops (L) together using
5
Plates (G, H) and Screws (J). Secure Tops (L) to base by turning Cams
(C). Insert Grommet (F) into Tops (L). Apply Cam Stickers (D) to all
exposed Cams (C).
L
L
6
P
J
Loading...