ASSEMBLY INSTRUCTIONS
TRANSACTION
BASIC 6' ADDER TABLE
NOTE: Please count and inspect all pieces before disposing of any carton or packing materials.
COMPONENTS:
Item # QTY. DESCRIPTION PART #
1 1 LEG, ADDER A8132**
2 2 MODESTY PANEL B8416**
3 1 WORKSURFACE L7219**
4 2 PANEL, CONF. LEG B8411**
HARDWARE BAG (PART No. A8128)
Item # QTY DESCRIPTION PART #
E1 2 TUBE INSERT, 5/16-18 T139*
E2 2 GLIDE Q608*
E3 8 SCREWS #10-32 x 1/2" X204*
When ordering components, specific color and/or size information may be required.
Contact a Mayline Customer Service Representative. 1-800-822-8037
** Denotes Color Code
* for individual item, order that part number
E4 28 SCREW #10 x 3/4 X11*
E5 2 SLAM LATCH Q643*
(1)
1. Install threaded inserts (E1) into Adder Leg (1).
2. Thread Glides (E2) into threaded inserts installed in Step 1.
3. Partially install Screws (E3) into the second holes from the top
and the bottom holes on both sides of the Adder Leg so that the
screw heads are approximately 1/8" from the leg.
4. Using the key hole slots in the ends of the Modesty Panels (2),
attach the Panels to Adder Leg. TIGHTEN FOUR SCREWS holding
panels at this time.
Top holes
remains OPEN
(2)
5. Assemble Starter Base per instructions included with that product.
Starter Base
8. Position Starter Worksurface over Starter Base and
loosely fasten in place using hardware and instructions
supplied with that product. Position Adder Worksurface (3)
on Adder Base and loosely fasten using Screws (E4)
through leg and side panels.
6. Move assembled Adder Base into position. Using the key hole slots in
the ends of the Modesty Panels (2), attach the Panels to the assembled
Starter Base. TIGHTEN FOUR SCREWS holding panels at this time.
7. Continue the Conference Table assembly by joining another Adder
Base or complete the Conference Table by joining the final section.
Starter Worksurface
Starter Base
9. Continue the Conference Table assembly by
installing another Adder worksurface or complete the
Conference Table by installing the final worksurface.
Once ALL tops are installed and aligned, tighten all
screws.
10. Install Slam Latch (E5) into Leg Panel (4) cutout as
shown.
11. Insert Leg Panel (4) into Adder Leg slots. Rotate Leg
Panel till slam latches catch.
(3)
Loading...