Page 1
BETTER FOR YOUR BUSINESS
ASSEMBLY INSTRUCTIONS
TRANSACTION 12' CONFERENCE TABLE
NOTE: Please count and inspect all pieces before disposing of any carton or packing materials.
COMPONENTS:
Item # QTY. DESCRIPTION PART #
1 4 LEG A8073**
2 1 CENTER LEG A8046**
3 2 PANEL ASSEMBLY TACEP**
4 4 SIDE PANEL B8371**
5 2 WORKSURFACE CALL**
6 2 INNER LEG PANEL - END B8299**
7 2 INNER LEG PANEL - ADDER B8411**
When ordering components, specific color and/or size information may be required.
Contact a Mayline Customer Service Representative. 1-800-822-8037
** Denotes Color Code
HARDWARE BAG (PART No. A8127)
* for individual item, order that part number
Item # QTY DESCRIPTION PART #
E1 6 TUBE INSERT, 5/16-18 T139*
E2 6 GLIDE Q608*
E3 4 GLIDE Q630*
E4 34 SCREWS #10-32 x 1/2" X204*
E5 46 SCREW #10 x 3/4 X11*
E6 4 SLAM LATCH Q643*
(1)
Page 2
1. Install threaded inserts (E1) into legs (1 & 2).
2. Thread glides (E2) into threaded inserts installed in Step 1.
3. Thread glides (E3) into bottom of panel assembly.
4. Attach legs (1) to panel assembly (3) with screws (E4).
5. Partially install screws (E4) into the second hole from the top
and the bottom holes of each leg assembly (1) and center leg (2) so
that the screw heads are approximately 1/8" from the leg.
6. Using the slots in the side panel ends (4), attach panels to leg
assemblies. TIGHTEN ALL SCREWS AT THIS TIME.
Top holes
remain open
(2)
Page 3
7. Install slam latch (E6) into inner leg panel cutout
(6 & 7) as shown.
8. Insert inner leg panels (6 & 7) into assembled leg
panel slots. Rotate inner leg panel till slam latch
catches.
9. Position worksurface (5) on base
assembly and fasten using screws (E5)
through legs and side panels.
(3)
Loading...