May Cheong Toy Fty 8102RC49 Users Manual

The packaging has to be kept since it contains important information.

Maisto Radio Control Vehicles

Contents:

RC Vehicle x 1
Transmitter x 1
Transmitter Antenna x 1
4-Hour Battery Charger x 1

9.6V Rechargeable Ni-Cd Battery Pack (For Vehicle Use) x 1
9V non-rechargeable Battery - 6F22 (For Transmitter Use) x 1
Instruction Manual x 1

Battery Charging:

1. Connect the 9.6V Battery Pack and the Charger connectors.

2. Plug the Charger into a standard 110V electrical outlet.

3. Charging time is around 4 hours.
When charging is complete, detach the connectors and remove the

4.

Charger from the electrical outlet.

Transmitter: Battery and Antenna Installation

1. Switch the power OFF.

2. Open the Battery Cover.
Install a 9V Battery with correct polarity (+/-) as shown

3.

inside the battery compartment.

4. Close the Battery Cover.

5. Screw the Antenna into the Transmitter securely.

Vehicle: Battery Pack installation

1. Switch the power to the OFF position.
Turn the Battery Knob and lift up the Battery Cover.

2.
Install the Battery Pack into the battery compartment and plug it into the connector correctly.

3.

4. Close and lock the Battery cover.

How to play:

1. Fully extend the Antenna of the Transmitter.

2. Match the Transmitter with the Vehicle Channel (Channel A or B or C).

3. Switch ON the Transmitter, the red LED will light up.

4. Switch ON the Vehicle.

5. The Headlight Features (OFF, Low beam and Hi-Beam) can be controlled on the Transmitter.

6. Pull the trigger to go forward, push it to go backward and release it to stop.

7. Turn the Transmitter steering wheel to move the Vehicle left or right.

8. If the Vehicle does not run in a straight line, adjust the wheel alignment arm on the Vehicle chassis.

9. Switch OFF the Transmitter and Vehicle power after playing.

Performance Tips:

1. Do not drive on grass, sand, carpet or go through water.

2. Do not drive in windy or rainy weather.

3. Avoid colliding with hard surfaces.

4. Switch OFF the Vehicle and Transmitter when not in use.

5. Remove all Batteries from the Vehicle and Transmitter when not in use.

6. Fully extend the antenna for best performance and do not point the antenna toward the vehicle.

7. Keep fingers, hair and loose clothing away from the wheels.

8. The operating range can be affected by a variety of factors:
a) Weak Transmitter Battery, or under-charged Battery Pack.
b) Interference from other items that emit radio frequency signals such as another R/C item on the same

frequency, CB radios, cordless phones, high voltage transformers, etc.
Outdoor usage is recommended in order to get optimal control range (100 feet or 30 meters).

9.

Cautions :

The 9.6V Battery Pack must be charged before use by utilizing the 4-Hour Battery Pack Charger which is included.
Do not overcharge the Battery Pack. Do not charge for more than 6 hours.
Do not charge the Battery Pack if it shows leakage, corrosion, or has loose or exposed wires or other damage.
Do not cover the Battery Pack with any sort of material while charging.
Do not touch the Battery Pack when it is hot. Wait until the Battery Pack cools before installing it in the vehicle and before recharging.
Do not dispose of the Battery in fire.
Do not dismantle the Battery or Charger, and do not cut the Battery or Charger cables.
The Battery Pack will be warm after charging, and hot after use in a vehicle.
The supply terminals are not to be short-circuited.
Rechargeable Batteries are to be removed from the toy before being charged.
Rechargeable Batteries are only to be charged under adult supervision.

Charge Only Ni-Cd Type (700mAH Max.) rechargeable Battery Packs. Other types of Batteries may burst causing injury to persons
and damage. This power unit is intended to be correctly orientated in a vertical or floor mount position.
Regular examination of Battery Charger for any damage to their cord, plug, enclosure and other parts, and that, in the event of such
damage, it must not be used with the Charger or Battery Pack charge until such damage has been repaired.

Note that the 9V Battery is non-rechargeable and is not to be recharged. Only batteries of the same or equivalent type as
recommended are to be used. It will need replacement when transmission is poor. Exhausted batteries are to be removed from the
Transmitter.

FCC Label Compliance Statement:

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.

- Consult the dealer or an experienced radio/TV technician for help.

The Manufacturer is not responsible for any Radio or TV interference caused by unauthorized modifications to this equipment. Such
modifications could void the User's Authority to operate the equipment.