May Cheong Toy Fty 07159RC27 Users Manual

Maisto Radio Control Vehicles

The packaging and instruction manual contain important information. Please keep them for future reference.

Contents:

RC vehicle x 1
RC transmitter x 1
Instruction manual x 1
Transmitter antenna x 1

Battery Requirement :

Vehicle : Built in 1.2V rechargable battery (non-replaceable).
Transmitter : 2 x 1.5V "AA" / LR6 alkaline batteries (not included).

Transmitter: Battery and Antenna Installation

1. Open the battery cover using a screwdrive (not included).
Install two new AA 1.5V batteries with correct polarity (+/-) as shown

2.
inside the battery compartment.

3. Fasten the battery cover.

4. Screw the antenna into the transmitter securely.

Vehicle: Battery charging

1. Switch OFF the vehicle.

2. Park and plug the car into the charging terminal of the transmitter
A red LED indicator on the transmitter lights up during charging. The

3.
charging cycle complete when the indicator turns off

HOW TO PLAY :

1. Switch ON the vehicle.

2. Drive the vehicle forwards and backwards by pressing the FORWARD and BACKWARD buttons respectively.

3. Turn the transmitter steering wheel to move the vehicle left or right.

4. If the vehicle does not run in a straight line, adjust the wheel alignment lever on the vehicle chassis.

5. Remember to switch OFF the vehicle power after playing.

Performance Tips:

1. Do not drive on grass, dirt, sand, carpet or go through water.

2. Do not drive in windy or rainy weather.

3. Avoid direct impact with obstacles.

4. Switch off the vehicle when not in use.

5. Keep fingers, hair and loose clothing away from the wheels.

6. The operating range can be affected by a variety of factors:
a) weak transmitter's or vehicle's batteries.
b) Interference from other items that emit radio frequency signals such as another R/C item on the same frequency, CB

radios, cordless phones, high voltage transformers, etc.

BATTERY USE

1. Alkaline batteries are recommended to use.

This devi

2. Only batteries of the same or equivalent type as recommended are to be used.

3. Do not mix alkaline, standard or rechargeable batteries.

4. Do not mix old and new batteries or different type of batteries.

5. Non-rechargeable batteries are not to be charged.

6. If rechargeable batteries are used, they are only to be charged under adult supervision.

7. Rechargeable batteries are to be removed from the product before they are charged.

8. Be sure to insert batteries with the correct polarities and always follow the battery manufacturer's instructions.

9. Remove all batteries from the transmitter when not in use.

10. Exhausted batteries are to be removed from the product.

11. The supply terminals are not to be short-circuited.
Dispose of batteries properly. Do not dispose the batteries in fire — it may cause them to explode or leak causing

12.
injury or damage.

CAUTIONS

1. Do not attempt to disassemble the products.
Do not operate the vehicle with same frequency with other players in same location that will interfere and make the vehicle

2.
out of control.

3. Make sure the batteries are Installed with correct polarity (+/-) as shown inside the battery compartment.

FCC Label Compliance Statement:

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :

1. This device may not cause harmful interference, and

2.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-

The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the User's Authority to operate the equipment.

ce must accept any interference received, including interference that may cause undesired operatio

RSS-310 Compliance Statement :

This radiocommunication device complies with all the requirements of Industry Canada Standard RSS-310.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept

any interference, including interference that may cause undesired operation of the device.

TROUBLE SHOOTING

Problem Cause Correction

No Function Low battery level Replace with new batteries

Battery polarities are reversed

The wheels are obstructed by foreign objects Remove foreign objects on the vehicle / wheels

Drive Slow / Low battery level Replace with new batteries
Poor Turning Signal The wheels are obstructed by foreign objects Remove foreign objects on the vehicle / wheels

Poor distance control Low battery level Replace with new batteries

Strong interference of surroundings Move to a better location for playing

Insert the batteries with correct polarities as shown
on the battery compartment

WARRANTY

All Maisto R/C vehicles have a 30 day limited warranty in function and performance. You may receive a new replacement vehicle
if the defective vehicle is returned to Maisto freight prepaid and confirmed to be factory defective. We are not responsible for
defects due to abusive use, or damaged for reasons other than factory defects. We also reserve the right to make the final
judgment and decision. Check the FAQ section before you return the unit to Maisto.