Maxx Ice MIDX200 User Manual

MAXX ICE

MID200 Series Ice Dispenser

Installation & Operation Manual

Maxx Cold Food Service

Weston, FL 33331 U.S.A. Phone: (954) 202-7419 Fax: (954) 202-7337

www.maxximumfoodservice.com

This manual is updated periodically. Visit http://www.maxximumfoodservice.com for the latest version.

MAXX COLD FOOD SERVICE

A DIVISION OF THE LEGACY COMPANIES, LLC

Installation & Operation Manual

MID200 Series Ice Dispenser

Unauthorized reproduction of this manual is freely permitted for all purposes except for monetary gain.

It is not guaranteed that this service manual is up to date, technically correct, complete, or free from writing problems or that the product is free from minor flaws or that it meets the needs of the customer.

November 2019

Table of Contents

Section 1 General Information

Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Model Number Key . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Date Code Key . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Serial Number Plate Location . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Section 2 Installation

Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Carton Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Installation Requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Plumbing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Electrical . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Section 3 Operation

Construction and Operation . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Adjustments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Section 4 Service Information

Cleaning Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

Storage and Winterization . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Removal from Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Problems and Solutions . . . . . . . . . . . . . . . . . . . . . . . . . 10

Safety Warnings and Information

WARNING: Indicates a potentially hazardous situation that may result in serious injury

or death.

CAUTION: Indicates a potentially hazardous situation that may result in personal injury.

The situation may also result in equipment or property damage.

WARNING: Use only genuine MAXX ICE replacement parts, Use of non-approved parts

when servicing MAXX ICE equipment may create a safety hazard, cause equipment damage, property damage and will void the warranty.

Special attention should be given to potential hazard labeling on the equipment and the signal words and symbols that are used throughout this manual. They may also be used to alert against unsafe practices.

Note: Indicates installation, operation, or maintenance information which is important, but not related to personal injury or property damage.

Note:

Check for freight damage before proceeding with the equipment installation. Be sure to inspect the equipment carefully for any damage that may not have been evident on the outside of the carton. Contact the freight carrier immediately to report any damage and file a claim. Have carrier note the damage on the bill of lading. Call Maxx Cold with your claim number to arrange replacement or repair.

• Read the entire manual before installing, operating or servicing the machine.

• Follow these installation instructions exactly.

• All machines have been tested and adjusted for correct performance at the factory.

• Knowledge of proper installation and service procedures is essential for the safe operation and

maintenance of MAXX ICE equipment. Refer all installation and service work to qualified technicians.

• This equipment must be installed in compliance with the applicable federal, state/province, and/or local

plumbing, electrical, and health/sanitation codes and requirements.

• Always disconnect the power supply before servicing the equipment or when the equipment will not be

used for a period of time.

• Never operate equipment that has been damaged or does not have all the protective covers in place.

• Never operate equipment that has been altered from the original MAXX ICE specifications.

Ice Dispenser Identification

Model Number Key

Standard Series

MID 200 Hotel Dispenser 115V 60HZ 1PH

MID 200 (F0) Hotel Dispenser 208-230 60HZ 1PH

MID 200 (E0) Hotel Dispenser 220-240 50HZ 1PH

X Series

MIDX 200 Hotel Dispenser 115V 60HZ 1PH

MIDX 200 (F0) Hotel Dispenser 208-230 60HZ 1PH

MIDX 200 (E0) Hotel Dispenser 220-240 50HZ 1PH

Note: The serial number plate is located behind the front cover, on the upper support. A complete model number and date code are essential for the accurate identification of the ice dispenser and proper selection of replacement parts.

+ 9 hidden pages