Maxx Ice MCR3UO Maintance Manual
INSTRUCTION
MANUAL
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USE
English
MCR3U
Indoor Refrigerator
Be sure unit is standing upright 24 hours prior to plug-in.
MCR3UMAN 0511 REV B
IMPORTANT SAFEGUARDS
Read all instructions before using this appliance. Use this appliance only for its intended purpose as described in this instruction manual. Always exercise basic safety
precautions, as described below. After reading the instruction manual, store it in an
accessible place where the user(s) of this product can easily find it.
The purpose of these safety precautions is to ensure safe and correct use of the product to minimize risks that could cause serious damage and injury to you or others. The
safety precautions are divided into WARNINGS and CAUTIONS. Cases where improper handling of the unit could lead to death or serious injury are listed under the
WARNING heading. However, the cases listed under CAUTION could also lead to serious results. To ensure safety, adhere strictly to both types of safety precautions.
IMPORTANT SAFEGUARDS
1. All repairs, disassembly and modifications should be per formed only by qualified
technicians. Attempting to perform these yourself could result in fire, malfunction or injury.
2. Never splash water directly onto the product or wash it with water without unplugging, as a short circuit could result. In a rainy environment, a water-proof covering is
recommended.
3. Never put flammable or volatile substances into the unit as explosion and fire could
result.
4. Do not damage, modify, excessively bend, strain, twist or bundle the power cord.
Also, placing heavy objects on the power cord or binding it could damage the cord,
possibly resulting in electrical shock or fire.
5. Use a dedicated wall outlet. Do not use an extension cord or multiple-outlet adaptor as this could result in electrical shock, overheating and fire.
6. Never use flammable spray cans or leave flammable substances near the unit.
Sparks from electrical switches could result in explosion or fire. If a combustible gas is
present near the appliance, turn off the source of the gas, then open the windows and
doors to allow the gas to dissipate. To avoid an explosion, do not pull the plug or switch
off the unit.
7. The electrical socket must have good grounding. The ground wire cannot be connected with a gas pipe, heating pipe, water pipe, telephone line or lightning rod. It
cannot be replaced with the neutral wire of single-phase power. In addition to the
ground wire, an electrical leakage circuit breaker is also required.
8. If installation in a damp location is unavoidable, have an electrician install a ground
fault circuit interrupter (GFCI) electrical outlet. If no GFCI is installed, electrical shock
could result.
9. Never climb onto the unit. The unit could tip over or fall and cause material damage or personal injury.
10. Disconnect the power cord plug from the wall outlet before moving the unit and
make sure that the power cord is not damaged during transport. A damaged power
cord could result in electrical shock and/or fire.
11. Never unplug the unit by pulling on the power cord. Always grip the plug firmly and
pull straight out from the outlet. Pulling the cord could cause wire breakage, possibly
resulting in overheating and fire.
12. Repair or replace any cord that is frayed. Do not use a cord that shows cracks or
abrasions along its length.
1. This unit must be properly installed in accordance with the installation instructions
before it is used. See grounding instructions in the Installation section.
2. This model can either be built-in or free-standing. Built-in units vent at the bottom
front and airflow at the front of this vent must be unimpeded.
3. Install the unit in a location where the floor is sturdy enough to support the load of
the unit. If the floor is not sturdy enough or installation is incorrectly performed, the unit
could tip over and cause personal injury. If the unit is placed on a stand, the front surface must be 3” or more back from the edge of the stand in order to avoid accidental
tipping of the appliance during normal usage.
4. Never place heavy objects or items containing water on top of the unit. Objects
could fall and cause injury and spilled water could cause the deterioration of the insulation of electrical components and result in electrical shock.
5. Disconnect the unit if it is behaving abnormally, and do not reconnect until the situation is corrected.
6. Pull out the plug before doing any maintenance on the unit to avoid electric shock.
7. Never pull out plug when hands are wet!
8. This unit is not intended for the storage of medicines or chemical reagents.
9. Keep packing materials away from children.
10. Condenser water from evaporator drains into a hole in the floor of the storage compartment and is channeled into a drain pan located at the back of the unit on the
compressor. Heat transferred from the compressor evaporates any water that has collected in the pan. Be sure the drain hole in the floor of the unit is clear and unobstructed.
11. During long absences, remove the unit’s contents, unplug the unit, clean it and
leave the door open slightly to avoid possible formation of condensation, mold or
odors. Use a cover to protect the unit and prolong its lifespan.
12. Leave disassembly and disposal of the unit to qualified experts.
SAVE THESE INSTRUCTIONS!
DANGER!
3
TECHNICAL SPECIFICATIONS
Shelves
Door
Leveling legs
Vents
L
ight Fan
Light switch
L
ight
S
F
Vents
ht switch
veling le
Model Number: MCR3U
Description: Indoor Refrigerator
Electrical Input: 115VAC ~ 60Hz
Current Rating: 2.0A
Unit Dimensions: 14⅝”W x 24⅜”D x 33½”H
Unit Weight: 69 lbs/31.29kg
371.475 mm W x 619.125 mm D x 850.9 mm H
Ambient Temperature Range: 25ºF - 100ºF /3.8ºC -37.77ºC
Compartment Temperature Range: 35ºF - 50ºF / 1.66ºC - 10ºC
Energy-Saving Tips
• Do not place the unit next to a heating vent, a range or in direct sunlight.
• Keep the door closed as much as possible, especially in hot, humid weather.
• Cover foods to reduce moisture buildup inside the appliance.
LOCATIONS OF PARTS
4
Loading...