MAXSA 40334 Operating Instructions

The Perfect Solar Light for Flags or Signs

ASSEMBLY AND OPERATING INSTRUCTIONS

Model #: 40334

Page 1

IMPORTANT: Read all instructions carefully before use.

ABOUT YOUR SOLAR FLAG LIGHT

Your MAXSA Solar Flag Light converts sunlight into electricity during
the day, enabling the Super bright LED light to turn on automatically
at night to light up your flag.

Your Solar Flag Light can light for up to 6.5 hours at full power and 13
hours at half power/brightness when the battery is fully charged. The
3 sealed rechargeable AA size NiMH 1200 mAh batteries included
with this product should last for many years before they need to be
replaced.

INCLUDED PARTS

Carefully remove and identify all the parts from their protective
packaging and lay them out in front of you.

HOW TO INSTALL YOUR SOLAR FLAG LIGHT

MOUNTING TO A FLAGPOLE

To mount on a flagpole, position the flagpole mounting bracket
supplied against the flagpole and run the two supplied metal bands
through the bracket as shown.

Put the bracket up to the pole and close the metal bands around the
pole, making sure the bands are pulled tight so the light is firmly
secured.

CAUTION: Do not tighten the metal bands until your Solar Flag
Light is placed where you want it. The bands cannot be reopened.*

CHOOSING A SUITABLE LOCATION

Position the solar panel so that it faces the southern sky. Placing the
panel in a shaded location will not allow the batteries to charge fully,
reducing the number of hours the light will operate per evening.

The Solar Powered Flag Light is equipped with a lightsensitive trigger
to automatically turn the light on at dusk. For best performance,
ensure that the Flood Light is not placed near nighttime light sources
such as porch lighting and street lighting.

OPERATING YOUR SOLAR FLAG LIGHT

BEFORE USING YOUR SOLAR FLAG LIGHT

If you are able to: Charge the batteries without activating the unit by
keeping the power switch turned off on the main body for three days
while your solar panel is in direct sunlight. This will ensure that the
batteries in your Solar Flag Light have a full charge prior to normal
operation.

After the initial 3 day charge of your Solar Flag Light, press the switch
on the main body to the ON position to make the light turn on
automatically after sundown. Set the switch to the OFF position to
turn on the light manually. Your Solar Flag Light is now ready for use.

Depending on how long you prefer the light to last, you can double
the light duration and reduce the brightness by pushing the bright­ness control switch so that you get 5 -6 hours of light at full brightness
or 10-12 hours at ½ brightness so you can light up your flag all night.

NOTE: When you first turn th light ON, it should activate immedi­ately, regardless of lighting conditions or motion. This is a test activa­tion to show there is power flowing from the battery to the light. It
should last roughly 5 seconds. After this test activation, the light will
function based on the dial settings mentioned below.

OPERATING YOUR SOLAR FLAG LIGHT

STORAGE

If you wish to store the light indoors for more than two or three days, press the power button to the
OFF position to prevent damaging the batteries.

MAINTENANCE

The LED lights in your Solar Flag Light will last up to 30,000 hours and should never need replace­ment.

To keep your Solar Flag Light looking new, keep the lens free of dust and deposits by wiping
occasionally with a dry cloth or with warm soapy water if necessary. A dirty solar panel will not allow
the batteries to fully charge and this will shorten the life of the batteries and may cause the light to
malfunction.

CHANGING THE BATTERIES

The included rechargeable batteries will last approximately 3 years. The battery can be accessed by
removing the rear panel. Remove the 4 corner screws to reveal the battery compartment.

The batteries we use are 3 pieces AA size 1200 mAh .1.2V Ni-MH rechargeable batteries.

TROUBLESHOOTING

PROBLEM SOLUTION

Light will not switch on.

Ensure that the power button on the main body has been turned to the ON position.

Ensure that the batteries have been fully charged in direct sunlight for 3 sunny days-refer to the “Before First Use
of Your Solar Security Light”. Artificial light will not charge the battery. It must charge in sunlight.

Page 2

Remove the 4 corner screws to

access the battery compartment

Check to see that the solar panel is facing South and that it receives 6-8 hours of sunlight per day, enabling the
batteries to fully charge.

* Check to see that the flood light is not near nighttime light sources such as street lights

Light quickly flashes on and
off.

Light is not as bright as
normal

Battery charge may be low. Turn the power switch to the OFF position and charge the batteries for three (3)
sunny days, ensuring the solar panels have been placed in direct sunlight.

Battery charge may be low. Turn the power button to the OFF position and charge the batteries for three (3)
sunny days, ensuring the solar panel has been placed in direct sunlight.

The brightness control switch might be set to HALF mode, which is designed to use less power, but keep the light
illuminated for a longer time period.

Check to make sure solar panel is facing South, and that it receives 6-8 hours of sunlight per day.

90 DAY LIMITED WARRANTY

90 DAY LIMITED WARRANTY: MAXSA Innovations, LLC warrants to the original consumer/purchaser that this product shall be free of defects in material and workmanship under normal
use and circumstances for a period of ninety (90) days from the date of original purchase for use. When the original consumer/purchaser returns the product pre-paid (consumer pays return
shipping) to MAXSA Innovations, LLC, 8412 Cathedral Forest Dr; Fairfax Station, VA 22039; USA within the warranty period, and if the product is defective, MAXSA Innovations, LLC will at
its option repair or replace such. This warranty shall constitute the sole liability of MAXSA Innovations, LLC concerning the product. MAXSA Innovations, LLC expressly disclaims all other
warranties INCLUDING, WITHOUT LIMITATION, THE WARRANTIES OF MERCHANT ABILITY AND FITNESS FOR A PARTICULAR PURPOSE. NO PERSON, FIRM, OR COPORATION
IS AUTHORIZED TO ASSUME FOR MAXSA Innovations, LLC ANY OTHER LIABILITY IN CONNECTION WITH THE SALE AND USE OF THE PRODUCT. MAXSA Innovations, LLC and
agents and distributors will bear no liability whatsoever for incidental or consequential damages or charges of any kind. Some states do not allow the reclusion or limitation of incidental or
consequential damages, so the above disclaimer regarding incidental or consequential damages may not apply to you. This warranty is void if the product has been damaged or tampered
with or if the product or any such parts have been opened. In all cases of damage during shipment, a claim must be filed with the shipping carrier and not with MAXSA Innovations, LLC.
This warranty gives you specific legal rights; you may also have other rights which vary from state to state.

[e-mail]

v14-2

©2014 MAXSA Innovations, LLC