maxmedix Circulator User Manual
Quick Guide
STEP#1
Plug the power cable into the nearest
electricity socket and the power input of
the device.
STEP#2
Sit down on a chair or a sofa and place
both of your bare feet on the foot
shaped pads of the device.
STEP#3
To turn the device ON, press the power
button on the device or the remote control.
Adjust the intensity through -/+ button.
STEP#4
Connect the electrode pads with the
connecting wire. Now plug this wire into the
accessories socket on the device.
STEP#5
Peel off the protective membrane from the body pads and
carefully place them on clean, dry, uninjured skin.
USER MANUAL
Please read the user manual carefully
before using the product
TM
ENGLISH
Sole / Foot Pads
Time Buttons
-/+ 1-60 minutes
(default 30 minutes)
Sole Intensity Level Buttons
-/+ 1-99 (Electrode pads)
Body Intensity Level Buttons
-/+ 1-99 (Electrode pads)
Power Button
Press to turn device on/off
Power and Accessory Sockets
Power and Electrode Pads sockets (simply
plug in the leads, connect the pads and
select body intensity levels)
AC/DC Adaptor
Remote Control
Electrode Pads
To target speciļ¬c areas of pain and swelling
Table of Contents
Key Components
Key Components
Instruction for using Foot Pads
Foot Pads
Body Pads
Remote Control
Indications for use
Contraindications
Additional Warnings
Health and Safety Precautions
Frequently Asked Questions
Troubleshooting
Quick Guide
3
4
6
7
8
8
9
10
14
20
maxmedix.com
Instructions for using Foot Pads
WE STRONGLY RECOMMEND THAT YOU READ THE CONTRAINDICATIONS
BEFORE USING THIS PRODUCT TO ENSURE YOUR SAFETY.
FOOT PADS
Foot and Leg Stimulation
Insert the two AAA batteries provided into the remote
control.
Plug the device into the nearest electricity socket.
Sit down on a chair or a sofa and place the device in
front of you on the ground.
Please do not stand on the device
Place both of your bare feet on the foot shaped pads
on the device.
Important: Remove your shoes, socks and stockings
before using the device. Both the feet are required for
the stimulation to work
Sit comfortably with both your knees bent at 90
degree angle for maximum effect.
Recommendation
Although it is not mandatory, we recommend that
you apply balm on your feet to improve its conductivity.
To turn the device ON, press the power button on
the device or the power button on the remote control.
When turned on, the default duration shows 30
minutes and intensity is also defaulted to zero (0).
1.
2.
3.
4.
Either directly through the device or using the remote
control, adjust the intensity through -/+ button.
Continue to increase the intensity until you either feel
or see your feet and calves muscles contracting and
expanding. Please note that the optimal intensity level
varies from person to person.
5.
Similarly, either directly through the device or using the
remote control, adjust the duration through -/+
button.
For optimum result, please do not lift your feet while
the device is on.
6.
The device will turn off automatically once it has
run for the duration chosen. Alternately, you can switch
off the device by pressing the power button or the
remote control.
7.
maxmedix.com
TM
Loading...