maxitrak 3/4 Scale Allchin Instruction Manual

Maxitrak Ltd 10-11 Larkstore Park, Lodge Road, Staplehurst, Kent, TN12 0QY

Tel: [phone] Email [e-mail]

¾” Scale Allchin

Steam Roller Conversion Instruction Manual

Maxitrak Ltd 10-11 Larkstore Park, Lodge Road, Staplehurst, Kent, TN12 0QY

Tel: [phone] Email [e-mail]

Welcome to the hobby of Model Engineering, from

Maxitrak Ltd.

We thank you for selecting one of our models, which we trust will provide you with long-term

enjoyment, in both its building and operation.

This construction manual provides build instructions and operational procedures for your

model. The same manual is supplied with all models, irrespective of how the model is
ordered i.e. Ready to Run, Fully Machined Painted Kit or Un-painted kit, therefore some
pages may not be relevant for your model, but nevertheless could be useful in the future.

We have a policy of continual improvement to our product range, including on-going updates

to the construction manuals. This is based on our own experiences and feedback from

customers. We invite customers to contact us regarding their experience on any matter

during the build or operation of their loco, should they consider there are errors,

misunderstandings or procedures that could be better described in this manual.

We aim to provide a good quality basic model that is easy to build, operate and maintain. We

also encourage, support, and will assist, customers who wish to implement their own

modifications, and we are also pleased to receive photographs of models to retain in our

files.

We wish to ensure that all customers are able to build and operate their model to their

expectations, for which we have a ‘help-line’ available to provide technical and operational

advice regardless how insignificant it may be considered.

We offer customers spares, servicing and boiler examination & testing facilities for all

locomotives.

The above information is also relevant should you have acquired your locomotive second-

hand.

Pleased be assured of our best and personal attention at all times.

Maxitrak Ltd 10-11 Larkstore Park, Lodge Road, Staplehurst, Kent, TN12 0QY

Tel: [phone] Email [e-mail]

Take the traction engine and remove the tyres from front and rear wheels. They pull off

sideways quite easily, keep them complete as they can be used round the roller wheels if

you don't want to scratch the paint.

Fit the rear rolls to the wheels, drill through the countersunk holes 2mm dia and bolt on

with countersunk 2mm screws, nuts on the inside.

Remove the steering chains from the front axle.

Remove the smokebox door, it is a press fit so ease it off with a small screw driver in the

slot under the smokebox.

Undo the bolts holding the saddle to the bottom of the smokebox.