MAX4599
Low-Voltage, Single-Supply,
SPDT Analog Switch in SC70
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS— Single +5V Supply
(V+ = +4.5V to +5.5V, V
INH
= +2.4V, V
INL
= +0.8V, TA= T
MIN
to T
MAX
, unless otherwise noted.) (Notes 2, 3)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
Voltage Referenced to GND
V+ .........................................................................-0.3V to +6V
IN, COM, NO, NC (Note 1) ...........................-0.3V to (V+ + 0.3V)
Continuous Current (any terminal)....................................±20mA
Peak Current, COM, NO, NC
(pulsed at 1ms, 10% duty cycle)..................................±40mA
Continuous Power Dissipation (T
A
= +70°C)
6-Pin SC70-6 (derate 3.1mW/°C above +70°C)...........245mW
6-Pin SOT23-6 (derate 7.1mW/°C above +70°C) ........571mW
Operating Temperature Range
MAX4599E_T ...................................................-40°C to +85°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
Note 1: Signals on NO, NC, COM, or IN exceeding V+ or GND are clamped by internal diodes. Limit forward-diode current to
maximum current rating.
DYNAMIC
DIGITAL I/O
ANALOG SWITCH
V+ = 4.5V, I
COM
= 1mA,
VNOor VNC= 3.5V
CONDITIONS
V
0V+
V
COM
,
VNO, V
NC
Analog Signal Range
Ω
40 60
R
ON
On-Resistance
65
UNITSMIN TYP MAXSYMBOLPARAMETER
TA= +25°C
TA= T
MIN
to T
MAX
TA= T
MIN
to T
MAX
V+ = 4.5V, I
COM
= 1A,
V
NO
or VNC= 3.5V
TA= +25°C
Ω
0.2 1
∆RON
On-Resistance Match Between
Channels (Note 4)
2
TA= T
MIN
to T
MAX
V+ = 4.5V; I
COM
= 1mA;
VNOor VNC= 1V, 2.0V,
3.5V
TA= +25°C
Ω
2.5 4
R
FLAT(ON)
On-Resistance Flatness
(Note 5)
5
V+ = 5.5V; V
COM
= 1V,
4.5V; VNOor VNC= 4.5V,
1V
TA= +25°C
nA
-0.5 0.01 0.5
I
NO(OFF)
,
I
NC(OFF)
NO, NC Off-Leakage Current
(Note 6)
TA= T
MIN
to T
MAX
V+ = 5.5V; V
COM
= 1V,
4.5V; VNOor VNC= 1V,
4.5V, or floating
TA= +25°C
nA
-1 0.01 1
I
COM(ON)
COM On-Leakage Current
(Note 6)
-10 10
TA= T
MIN
to T
MAX
-5 5
V
2.4
V
IH
Input Logic High
V
0.8
V
IL
Input Logic Low
VNO, VNC= 3V;
R
L
= 1kΩ; CL= 35pF;
Figure 2
TA= +25°C
ns
25 30
t
ON
Turn-On Time
TA= T
MIN
to T
MAX
40
ANALOG SWITCH
DYNAMIC
DIGITAL I/O