MAX349/MAX350
Serially Controlled, Low-Voltage,
8-Channel/Dual 4-Channel Multiplexers
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS—Dual Supplies
(V+ = +4.5V to +5.5V, V- = -4.5V to -5.5V, TA= T
MIN
to T
MAX
, unless otherwise noted. Typical values are at TA= +25°C.)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
Voltages Referenced to GND
V+...........................................................................-0.3V, +17V
V-............................................................................-17V, +0.3V
V+ to V-...................................................................-0.3V, +17V
SCLK,
CS, DIN, DOUT, RESET .................-0.3V to (V+ + 0.3V)
NO, COM.................................................(V- - 2V) to (V+ + 2V)
Continuous Current into Any Terminal..............................±30mA
Peak Current, NO or COM
(pulsed at 1ms, 10% duty cycle).................................±100mA
Continuous Power Dissipation (T
A
= +70°C)
18-Pin Plastic DIP (derate 11.11mW/°C above +70°C) ..889mW
18-Pin SO (derate 9.52mW/°C above +70°C)...............762mW
20-Pin SSOP (derate 8.00mW/°C above +70°C) ..........640mW
18-Pin CERDIP (derate 10.53mW/°C above +70°C).....842mW
Operating Temperature Ranges
MAX349C_ _, MAX350C_ _ .................................0°C to +70°C
MAX349E_ _, MAX350E_ _...............................-40°C to +85°C
MAX349M_ _, MAX350M_ _ ...........................-55°C to +125°C
Storage Temperature Range.............................-65°C to +150°C
Lead Temperature (soldering, 10sec).............................+300°C
CONDITIONS UNITS
MIN TYP MAX
(Note 1)
SYMBOLPARAMETER
60 100
VV- V+V
COM
, V
NO
Analog Signal Range
V+ = 5V, V- = -5V,
V
COM
= ±3V, INO= 1mA
Ω
125
R
ON
COM-NO On-Resistance
C, E, M
TA= +25°C
C, E, M
TA= +25°C 16
C, E, M
V+ = 5V, V- = -5V,
V
COM
= ±3V, INO= 1mA
Ω
20
∆R
ON
COM-NO On-Resistance Match
Between Channels (Note 2)
TA= +25°C 10
C, E, M
V+ = 5V, V- = -5V, INO= 1mA,
V
COM
= -3V, 0V, 3V
Ω
15
R
FLAT(ON)
COM-NO On-Resistance
Flatness (Note 2)
TA= +25°C -0.1 0.002 0.1
ANALOG SWITCH
C, E -5 5
V+ = 5.5V, V- = -5.5V,
V
COM
= -4.5V, VNO= 4.5V
M -10 10
TA= +25°C -0.1 0.002 0.1
C, E -5 5
NO Off-Leakage Current
(Note 3)
I
NO(OFF)
V+ = 5.5V, V- = -5.5V,
V
COM
= 4.5V, VNO= -4.5V
M -10 10
nA
TA= +25°C -0.1 0.002 0.1
C, E -10 10
M -100 100
TA= +25°C -0.1 0.002 0.1
C, E -5 5
V+ = 5.5V,
V- = -5.5V,
V
COM
=
±4.5V,
VNO= ±4.5V
M -50 50
TA= +25°C -0.2 0.002 0.2
C, E -10 10
M -100 100
TA= +25°C -0.2 0.002 0.2
C, E -5 5
COM Off-Leakage Current
(Note 3)
I
COM(OFF)
V+ = 5.5V,
V- = -5.5V,
V
COM
=
-4.5V,
VNO= 4.5V
M -50 50
nA
MAX349
MAX349
MAX350
MAX350