MAX2472/MAX2473
500MHz to 2500MHz
VCO Buffer Amplifiers
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
DC ELECTRICAL CHARACTERISTICS
(VCC= +2.7V to +5.5V, PIN= -25dBm, IN driven from a 50Ω source, OUT_ LC-matched to 50Ω, TA= T
MIN
to T
MAX
, unless otherwise
noted. Typical values are at V
CC
= +3V, TA= +25°C.) (Note 1)
AC ELECTRICAL CHARACTERISTICS—MAX2472
(
Typical Operating Circuits
, VCC= +3V, PIN= -25dBm, IN driven from a 50Ω source, OUT1 and OUT2 LC matched to 50Ω, TA=
+25°C, unless otherwise noted.)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
VCCto GND..............................................................-0.3V to +7V
OUT1, OUT2, BIAS to GND........................-0.3V to (VCC+ 0.3V)
Maximum BIAS Pin Current................................................150µA
Maximum Input Power....................................................+10dBm
Continuous Power Dissipation
SOT23-6 (derate 8.7mW/°C above +70°C)...................696mW
Operating Temperature Range ...........................-40°C to +85°C
Junction Temperature......................................................+150°C
Storage Temperature Range.............................-65°C to +150°C
Lead Temperature (soldering, 10sec).............................+300°C
CONDITIONS
2.7
mA
5.2 8.0
I
CC
V2.7 5.5V
CC
Input Voltage Range
Supply Current
4.8
5.1
2.5
4.3
UNITSMIN TYP MAXSYMBOLPARAMETER
MAX2473, R
BIAS
= 23kΩ
MAX2473, R
BIAS
= 11kΩ
MAX2472
No drive
MAX2472
MAX2473, R
BIAS
= 23kΩ
MAX2473, R
BIAS
= 11kΩ
dBm
S12
2
S21
2
fIN= 900MHz, TA= +25°C
Transducer Gain
(IN to OUT2)
fIN= 600MHz
fIN= 900MHz
dB
9.2
fIN= 900MHz
fIN= 2400MHz
fIN= 1900MHz
fIN= 600MHz
40
fIN= 1900MHz
fIN= 2400MHz
fIN= 900MHz
fIN= 900MHz, TA= T
MIN
to T
MAX
(Note 3)
CONDITIONS
dB
6.6 14.6
fIN= 600MHz 13.0
S21
2
fIN= 2400MHz 5.3
fIN= 1900MHz 6.8
Transducer Gain
(IN to OUT1)
dB
7.8 10.2 12.2
14.0
MHz500 2500f
IN
Input Frequency Range (Note 2)
26
30
43
Reverse Isolation
(IN to OUT2)
7.5
6.0
-3.2P
OUT1dB
Output 1dB Compression Point
UNITSMIN TYP MAXSYMBOLPARAMETER