Installation Instructions
53878 / E53878
Starstrand Electronic Dimmable Driver (includes 6ft male output cord)
Driver Installation:
Select desired location to mount drivers, which is not in contact with installation and
away from oven and/or other source of intense heat and as close as possible to the
lighting system to achieve the most efficient operation. (Drivers can be mounted
vertically or horizontally.
After firmly mounting the drivers, select a listed connector (not furnished) appropriated
tto the type of electrical supply cable on site.
Remove cover and knockout from drivers and fasten connector to terminal cover and
secure in place with connector.
If driver is being used in a damp or wet location, ensure open knockouts and/or connectors
are waterproof.
See reverse for electrical Wiring Diagram
WARNING: This driver has a 2.3 Watt minimum load and minimum dimmable load.
Do not use this driver with less than the required Load.
WARNING: Be sure that electricity to the wire you are working on is shut off, either the fuse
removed or the circuit breaker off.
WARNING: Use of the other manufacturers components will void warranty, UL. and/or ETL
listing, and create a potential safety hazard.
WWARNING: Risk of electric shock, not submersible.
WARNING: Do Not energize electrical supply circuit to drivers until all connections have been
made and tested according to national electrical codes and all local electrical codes. If you are
unclear on how to proceed, contact a qualified electrician
CAUTION: Risk of fire: 12V LED tape must not be used in a 24V system, and 24V LED tape
must not be used in 12V system.
CAUTION: The location and number of drivers installed on residential circuit breakers may
ccause the breakers to trip when the lighting load is energized. If this occurs, replace the residential
circuit breaker with a breaker rated for high in-rush current.
AC Input: 120V/60Hz 0.25A Max
DC Output: 24V (100% loading) 0.83A (Max)
Minimum Dimming Load: 2.3 Watt
Maximum Wattage: 20 Watts
PF:> 0.9
Efficiency: >75%
OOutput Current: 0.83-830mA
Maximum Output Power: 20 Watts
Dimming Down Ability: 20%
Installation Instructions
53878 / E53878
Starstrand Electronic Dimmable Driver (includes 6ft male output cord)