Maxdata 520, 220 installation guide

Page 1
MAXDATA PLATINUM 520/220 Installation Guide for the Rack-Mount Slide Rail Kit
Parts List
The following is a list of all the parts that are relevant for installation; each part is designated with a letter that is used in the installation guide.
External Rail
Middle Rail
Internal Rail
The middle rail (B) is slid inside the external rail (A) and the internal rail (C) in turn is inside the middle rail (B).
End Bracket
Round head screw, large
Round head screw, small
Nut
Perforated Plate with threaded holes
NOTE
Countersunk screws are not required.
Tip: Customers with a MAXDATA rack can simplify installation of the server by taking the screws, washers, and clamping nuts from the fastening set of their cabinet.
1MAXDATA PLATINUM 520/220
Page 2
Installation
1. Pull the internal rail (C) out of the middle rail (B).
2. Leave the middle rail (B) inside the external rail (A).
3. Measure the distance between the front and rear breadboard section of your cabinet. At-tach the silver end brackets (D) to the external rail (A) with two screws (E) and two nuts (G) each. Be careful to make sure that the distance between the fastening bracket for the external rail (A) and the end bracket (D) is the same as the distance between both bread-board sections of your server cabinet.
2 Installation Guide for the Rack-Mount Slide Rail Kit
Page 3
4. Attach the rails in the rear of the server cabinet with the silver end brackets (D). First hold the fastening bracket up to the breadboard. Then set the perforated plate with the threa-ded holes (H) behind the breadboard section. Finish by inserting the screws (E) from the front through the breadboard and the fastening bracket to the perforated plates (H)
Front : A
Rear : D
5. Attach the internal rails (C) with the locking device in the rear of the server housing with the small screws (F).
6. When finished, you can slide the server into the server cabinet by pushing the inner rail (C) into the middle rail (B). To be able to slide the server completely inside, you have to push in the locking device at both sides of the rails.
3MAXDATA PLATINUM 520/220
Loading...