Amplis DUPONT Amps – ADM Sarl – 20, Rue de Port Boutiers – 16100 Boutiers St Trojan (Cognac) France
Tél : 05.45.32.54.10 – Fax : 05.45.35.47.90 – www.dupontamps.com
ENGLISH
Congratulations, you have just acquired a STIMER M6 Amp model, conceived with the same classical
models sound's quality which benefits from modern technological advances.
It’s a tube amp 6 watt, Class A, with a vintage sound of the 50s. Completely made by Maurice Dupont
workshop (Cognac, France), point-to-point wiring and handmade, to avoid at most the losses of sound and
keep all the heat of tubes.
Ideal for the studio or to play at home, it will be also very surprising on stage.
Important:
-When turning on the amplifier, wait for 1 minute before activating the STANDBY for the tube to heat. The
tubes will last longer.
-Before any moving or shipping, make sure the tubes are cold. Even if they are solid, the filament are fragile
when hot.
-To turn off : turn off the STANDBY before switching off the amp.
-Never turn on the amplifier without plugging the speakers! Risk of burning the output transformer and
power tubes.
NEVER OPEN THE AMP, THERE IS VERY HIGH VOLTAGES INSIDE WHICH COULD
KILL YOU
Amplis DUPONT Amps – ADM Sarl – 20, Rue de Port Boutiers – 16100 Boutiers St Trojan (Cognac) France
Tél : 05.45.32.54.10 – Fax : 05.45.35.47.90 – www.dupontamps.com
FRONT
(From left to right)
- Secteur : Power supply, 230V or 115V according to the country
- Red Button : Thermal circuit breaker 0,60A.
- Marche : Switch on the amp (warm the tubes).
- Lampe : Power indicator light
- GAIN/ Standby : Pot with included switch to control the Standby in position 0. The other positions are to manage the
gain (volume).
- P.U. : Old phone input, today only aesthetics.
- Tone : Position 5: The tone has no effect.
Turn clockwise : More high frequencies.
Turn counterclock : More low frequencies.
-Boost: Activate upward to add crunch and volume.
-Jack d’entrée/Micro : Instead of both usual input, High and Low, there is only one input with a pot (MICRO) which
allows to pass from High to Low with diverse intermediate positions. It offers to the musician the possibility of adapting
the ampli to his guitar and allows to find nuances of tones which do not find somewhere else.
Specifications
Power : 6w
Pre amp tubes : 1 x 12AX7
Power tubes : 2 x EL84
Rectifier tubes : Lampe EZ81
Class : CLASS A
Output: 8 ohm
Controls: Gain, Tone, Boost, Micro
Model: Combo
Weight : 6,5 Kg
Dimensions : Height: 37,5 cm
....................... Width: 33,5 cm
....................... Depth: 15 cm
Speaker : 1 X 10" - 8 ohm
.................Jensen céramique
Amplis DUPONT Amps – ADM Sarl – 20, Rue de Port Boutiers – 16100 Boutiers St Trojan (Cognac) France
Tél : 05.45.32.54.10 – Fax : 05.45.35.47.90 – www.dupontamps.com
Tubes position
Maintenance
Attention, we advise you to contact a technician if you are not experimented.
- The tubes are standard models and are available at every good retailers. They have a life expectancy from 4000 to
6000 hours for a normal usage. It is imperative to make them warm before any use to guarantee them this life
expectancy. If you have to change them, always be careful not to burn you because they can be very warm, verify that
the supply is switched off and the cable disconnected. We recommend to replace them only by lamps of the same
model. Do not hesitate to contact us for any information.
- If there is no supply anymore when you switch on the amplifier, the circuit breaker is probably activated. In that case,
check that the button GAINS is in position 0 (standby), check that the button MARCHE is off, disconnect the grip of
supply and press on the circuit breaker.
- Be sure that the speaker is connected before switching on the amp. Pay attention that the impedance is compatible
(output jack 8 ohms).
- Do not put liquid on the amp.
- Let your ampli adapt itself in case of strong temperature variation before switching on it.
- Never forget that tubes are made of glass.
Loading...