Maurer Elektromaschinen Captest 1225 V2 Operation Manual

Operation Manual Captest 1225 V2 .

Operation Manual

Processor Controlled

Processor Controlled Processor Controlled

Processor Controlled

Capacity Tester

Capacity TesterCapacity Tester

Capacity Tester

12V 0.3A-25A

also for 24V 0.3A –25A

English Version

Operation Manual Captest 1225 V2 .

Introduction:

With this processor controlled capacity tester you can measure the capacity of the
batteries. You can set the cut off voltage (The voltage limit where you want to stop
the discharge), the discharging current, and the charging time between the cycles.
You can program 1-8 cycles. The tester measures the charged/discharged Ah and the
elapsed time since the start of each cycle.

Connecting the tester to the battery

After connecting the tester to the battery you can see the software version and the
serial number of the tester for a few seconds. After that, you can see the voltage of the
battery on the display.

Menu System:

The main menu consists of 5 screens. You can change between the screens with the
Display Change button.

1. Voltage screen

2. Test Parameter screen

3. Read Test Result

4. Charge

5.Discharge

5.Send data

Voltage

12.8 V

Test parameters

Read test result

Charge

Discharge

Measured data -PC