Mattel Toys A Division of Mattel 95087 00A2T User Manual

CONTENTS

Vehicle
Transmitter
Power Clip (if supplied)

6.0V Jet Turbo

®

Battery Pack (if supplied)

6.0V Jet Turbo

®

Charger (if supplied)

CHASSIS

Your vehicle’s chassis will look like 1 or 2
below, depending on the vehicle’s design.

Refer to label on transmitter and vehicle
for frequency. Do not race vehicles with
the same frequency.

Keep these instructions for future reference: they contain important information.
IMPORTANT: Please read all “Consumer Information” (last page) before operating your vehicle.

6.0V R/C

6.0V R/C

CAUTION:

Surfaces may become hot and cause burns if

electronics get wet. Do not operate vehicle through water or snow.

FORWARD REVERSE LEFT

RIGHT

VEHICLE OPERATION

ON/OFF
switch

ON/OFF
switch

steering
adjuster

steering
adjuster

battery
latch

battery
latch

NOT RECOMMENDED

FOR CHILDREN UNDER
6 YEARS OF AGE. AS WITH ALL ELECTRIC PRODUCTS,PRECAUTIONS SHOULD BE
OBSERVED DURING HANDLING AND USE TO PREVENT ELECTRIC SHOCK.

CAUTION-ELECTRIC TOY:

MODEL 32990: INPUT: 120VAC, 60Hz, 0.05A. OUTPUT: 6.3VDC, 230mA.
MODEL 95084-9609: INPUT: 120VAC, 60HZ, 0.04A. OUTPUT: 6.3VDC, 200mA, 1.3VA.

CHASSIS 1 CHASSIS 2

00007-1705

POWER SYSTEMS

TRANSMITTER BATTERY INSTALLATION

NOTE: Your transmitter is equipped with a special automatic
ON battery-saving feature. Just turn your vehicle ON. Then
push either transmitter stick and you will be able to run and
control your vehicle.

Some transmitters include a sound feature. The sound feature can
be deactivated by turning the sound switch to the OFF position.

1. To install transmitter battery, open battery door as shown.

2. Install one 9V battery with polarity (+/-) as shown inside battery
compartment.

3. Swing battery door closed and snap shut.

If your vehicle was supplied with a battery pack and charger,
please follow the specific instructions on the next page for
detailed information regarding NiCd vehicle battery charging
and safety. If your vehicle was not supplied with a battery pack
and charger, please follow the specific instructions that came
with your battery pack and charger.

VEHICLE BATTERY INSTALLATION

1. Rotate battery latch to open position.

2. Insert battery pack into battery compartment and slide it away
from latch.

3. Make sure battery pack snaps securely in place and rotate
latch to locked position.

4. To remove battery pack: turn latch, slide battery pack toward
latch and lift out.

battery
compartment

battery
door

vehicle controls

power
indicator
light

sound
switch
(if equipped)