Mattel Toys A Division of Mattel 92769 00A2T User Manual

CONTENTS

Vehicle
Transmitter
Power Clip (if supplied)

6.0V Jet Turbo®Battery Pack (if supplied)

6.0V Jet Turbo®Charger (if supplied)

CHASSIS

Your vehicle’s chassis may look slightly
different, depending on the vehicle’s design.

Refer to label on transmitter and vehicle for
frequency. Do not race vehicles with the
same frequency.

VEHICLE OPERATION

FORWARD

REVERSE

LEFT

RIGHT

92769-0920

ON/OFF switch

battery latch

high/low
gear selector

steering
adjuster

Keep these instructions for future reference: they contain important information.

6.0V R/C

6.0V R/C

CAUTION:

Surfaces may become hot and cause burns if

electronics get wet. Do not operate vehicle through water or snow.

POWER CLIP

Unscrew Power Clip cover screw and
remove cover. Insert 4 "AA" batteries, with
polarity (+/-) as shown inside Power Clip.
Replace cover.

VEHICLE BATTERY INSTALLATION

1. Rotate battery latch to open position.

2. Insert the battery you’re using into battery
compartment and slide it away from latch.

3. Make sure battery snaps securely in place
and rotate latch to locked position.

4. To remove: turn latch, slide toward latch
and lift out.

TRANSMITTER BATTERY INSTALLATION

NOTE: Your transmitter is equipped with

a special automatic ON battery-saving
feature. Just turn your vehicle ON. Then push
either transmitter stick and you will be able
to run and control your vehicle.

1. To install transmitter battery, open battery

cover as shown.

2. Install one 9V battery with polarity (+/-) as

shown inside battery compartment.

3. Replace battery cover.

vehicle controls

battery cover

battery compartment

power indicator light

POWER SYSTEMS

This vehicle can operate on 2 different power systems: the Power Clip (which uses 4 "AA" batteries) or the 6.0V NiCd rechargeable battery
pack. For detailed information regarding NiCd vehicle battery charging and safety, please follow the specific instructions that came with your
battery pack and charger.