Page 1
Keep these instructions for future reference as
they contain important information. IMPORTANT:
Please read all “Consumer Information” before
operating your vehicle.
3+
T4831 / T4832-0920
ASST. T4511
CAUTION:
burns if electronics get wet. Do not operate vehicle
through water or snow.
Surfaces may become hot and cause
®
I. CONTENTS / FEATURES
Vehicle
Transmitter
Vehicle
1
ON(I)/OFF(O) switch
2
Battery door
2
I
O
1
II. VEHICLE OPERATION
Transmit ter
1
1 Steering wheel control: forward / backward
to left
2
Battery door
1
2
Page 2
III. BATTERY INSTALLATION
1
2
3
4
6
5
Requires 2
AA Alkaline batteries for the vehicle and
2 AA Alkaline batteries for the transmitter. Batteries not
included.
Vehicle
1. Use a screwdriver (not included) to unscrew the
power clip cover screw, remove the battery cover.
2. Install
2 AA Alkaline
batteries (not included),
with polarity (+/-) as shown inside the battery
compartment.
3. Replace the battery door.
Transmit ter
1. Remove the battery cover as shown.
2. Install 2
AA Alkaline
batteries (not included),
with polarity (+/-) as shown inside the battery
compartment.
3. Replace the battery cover. Once the batteries are
installed the transmitter will always be “ON” and
will work automatically the moment you use it.
IV. QUICK TIPS
1. When your vehicle starts to lose power, it
may lose functionality or performance. It’s
time for fresh batteries.
2. Your vehicle’s running time may vary
depending on your driving style.
3. Radio interference can affect your
vehicle’s performance. Interference can be
caused by other R/C vehicles running on the
same frequency, electrical wires, large
buildings, CB radios or other wireless
gear. Try to stay away from these!
4. Point your transmitter up - not down
toward your vehicle. If your vehicle gets
too far away, it won’t work properly.
5. Don’t drive your vehicle through water
or snow. If your vehicle does get wet,
wipe it with a towel and allow it to dry
completely.
6. Don’t store your vehicle near heat or in
direct sunlight. Always turn switches OFF
and remove all batteries for storage.
Page 3
V. CONSUMER INFORMATION
Note to adults: To ensure that the child’s play is
both safe and fun, please review all operating
instructions and safety rules with your child.
Safety Tips
• NEVER drive your vehicle on streets! They’re
for real cars!
• DO NOT pick up vehicle while in motion.
CAUTION: To prevent entanglement,
keep hair away from wheels.
• Keep fingers, hair and loose clothing away from
the tires and the wheel hubs while the vehicle
is switched ON.
• Adult supervision is recommended when this
vehicle is being operated.
• To avoid accidental operation, remove all
batteries when not
in use. Always turn the
vehicle OFF before removing batteries.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak
fluids that can cause a chemical burn injury or
ruin your product. To avoid battery leakage:
• Non-rechargeable batteries are not to be
recharged.
• Rechargeable batteries are to be removed from
the product before being charged (if designed to
be removable).
• Rechargeable batteries are only to be charged
under adult supervision (if designed to be
removable).
• Do not mix alkaline, standard (carbon-zinc),
or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with the correct
polarity.
• Exhausted batteries are to be removed from the
product.
• The supply terminals are not to be short-
circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire.
The batteries inside may explode or leak.
WARNING: Inserting or changing batteries are
actions that must be done to Note to Adults: –
using the appropriate tool to open and close
battery compartment.
Battery Performance Note:
For best performance use regular or highperformance alkaline batteries (where
disposable batteries are called for). If your
vehicle is supplied with standard (carbon-zinc)
batteries for initial use and/or demonstration
purposes, we recommend replacing them with
alkaline batteries when necessary. Battery life
may vary depending on battery brand.
Protect the environment by not
disposing of this product with
household waste [2002/96/EC].
Check your local authority for
recycling advice and facilities.
© 2010 Mattel, Inc., 636 Girard Avenue, East Aurora, NY
14052, U.S.A. Consumer Relations 1-800-524-8697. • Mattel
Canada Inc., Mississauga, Ontario L5R 3W2. You may call us
free at 1-800-524-8697. • Mattel U.K. Ltd., Vanwall Business
Park, Maidenhead SL6 4UB. Helpline 01628 500303. • Mattel
Australia Pty., Ltd., Richmond, Victoria. 3121.Consumer
Advisory Service - 1300 135 312 Mattel East Asia Ltd., Room
1106, South Tower, World Finance Centre, Harbour City,
Tsimshatsui, HK, China. • Diimport & Diedarkan Oleh: Mattel
SEA Ptd Ltd.(993532-P) Lot 13.5, 13th Floor, Menara Lien
Hoe, Persiaran Tropicana Golf Country Resort, 47410 PJ.
Tel:03-78803817, Fax:03-78803867.
service.mattel.com
TM & © 2010 WWE, Inc.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
• This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part
15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
NOTE: Changes or modications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
Loading...