Mattel Asia Pacific Sourcing DNR84-16A5R, DNR84-16A5T User Manual

2

6

7

3

4

5

9.6V d.c. NiMH,

1 x 8AA 900 mAh.

8

1

QUICK TIPS

(1) When your vehicle starts to lose power, it may lose functionality or performance.

It’s time for a recharge. Your vehicle’s running time may change depending on
your driving style and driving environment.

(2) Radio interference can affect your vehicle's performance. Interference can be

caused by other R/C vehicles running on the same frequency, electrical wires,
large buildings or CB radios. Try to stay away from these!

(3) Point your transmitter up, not down toward your vehicle. If your vehicle gets too

far away, it won’t work properly.

(4) Don’t store your vehicle near heat or in direct sunlight. Always turn switches OFF

and remove all batteries for storage.

(5) Don't drive your vehicle in sand or through water or snow. Do not immerse in water.

If your vehicle or transmitter does get wet, wipe it with a towel, remove batteries,
and allow to dry completely overnight. Replace with fresh batteries before next use.

(6) When exposed to an electrostatic source, the product may malfunction.

To resume normal operation, remove and re-install the batteries. This should
reset your vehicle and let you resume normal operation.

RECHARGEABLE BATTERY INFORMATION

• DO NOT RECHARGE THE BATTERY PACK IF IT IS HOT. ALLOW IT TO
COOL BEFORE RECHARGING.

• DO NOT ATTEMPT TO USE OR CHARGE THE BATTERY PACK IF IT
SHOWS SIGNS OF LEAKAGE OR CORROSION.

• DO NOT DISASSEMBLE THE BATTERY PACK.

• EXERCISE CAUTION IN HANDLING A HOT BATTERY PACK.

• IF BATTERY PACK AND/OR CHARGER ARE WET, THOROUGHLY DRY
BEFORE CHARGING.

• DO NOT RECHARGE NON-RECHARGEABLE BATTERIES.

• DO NOT DISPOSE OF THE BATTERY PACK IN A FIRE.

NOTE TO ADULTS

• Recharge battery pack only under adult supervision.

• Periodically examine this product for damage to the plug, housing,
or other parts that may result in the risk of fire, electric shock or
injury. If the product is damaged, do not use it.

• The battery charger is not a toy.

• This battery charger is intended to be correctly oriented in a vertical
or floor mount position.

TM

DNR84-0970

INSTRUCTIONS

PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE AS THEY CONTAIN IMPORTANT INFORMATION.
IMPORTANT: PLEASE READ ALL INSTRUCTIONS BEFORE OPERATING YOUR VEHICLE.

1100869831_DOM

8+

CONTENTS

Adult supervision is recommended when the vehicle is being operated.

INSTRUCTION SHEET

SPECIFICATIONS

Toy:

Toy No.:

Part No.:

Trim Size:

Folded Size:

Type of Fold:

# colors:

Colors:

Paper Stock:

Paper Weight:

EDM No.:

RC_Terra Climber

White Offset

DNR84

0970

A3

A4

Black

70 lb.

BATTERY DISPOSAL

Unlike NiCd (Nickel-Cadmium) rechargeable batteries, your TYCO
disposal. However, as with all products, you should dispose of your battery pack in an environmentally responsible and considerate manner.

BATTERY SAFETY INFORMATION

In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the product before
being charged.

• Rechargeable batteries are only to be charged under adult supervision.

• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries.

• Do not mix old and new batteries.

•

Only batteries of the same or equivalent type as recommended are to be used.

Protect the environment by not disposing of this product with household waste (2012/19/EU). Check your local authority for recycling
advice and facilities.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.

Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

• This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

™

RC (NiMH) battery pack requires no special procedures or precautions for

• Batteries are to be inserted with the correct polarity.

• Exhausted batteries are to be removed from the product.

• The supply terminals are not to be short-circuited.

• Dispose of battery(ies) safely.

• Do not dispose of this product in a fire. The batteries inside may
explode or leak.

• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that

may cause undesired operation of the device.
This equipment complies with FCC & Canada radiation exposure limits
set forth for uncontrolled environments.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.

NOTE: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.

CAUTION - ELECTRICALLY - OPERATED PRODUCT:

NOT RECOMMENDED
ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING
HANDLING AND USE TO REDUCE THE RISK OF ELECTRIC SHOCK.

INPUT: 100-240VAC

CAUTION:

keep all hair away from the wheels.
Surfaces may become hot and cause
burns if electronics get wet. Do not
operate vehicle through water or snow.

ASSEMBLY

Line up the notch and the groove, then insert tail into the vehicle body. Push firmly until the tail locks into place.

©2016 Mattel. All Rights Reserved. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Services 1-800-524-8697. Mattel
U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline 01628 500303. Mattel Australia Pty., Ltd., Richmond, Victoria. 3121.Consumer
Advisory Service - 1300 135 312. Mattel East Asia Ltd., Room 503-09, North Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Tel.: [phone]. Diimport & Diedarkan Oleh: Mattel Southeast Asia Pte. Ltd. , No 19-1, Tower 3 Avenue 7, Bangsar South City, No 8, Jalan
Kerinchi, 59200 Kuala Lumpur, Malaysia. Tel: [phone], Fax: [phone].

FOR CHILDREN UNDER 8 YEARS OF AGE. AS WITH ALL

,

50/60HZ

,

8W

.

OUTPUT: 11.2VDC

To prevent entanglement,

SERVICE.MATTEL.COM

, 0.

28A

, 3.

1W.

®

FEATURES

1

BATTERY COVER

ON (I) / OFF (O)

2

3

RED/GREEN LED

4

RED LED

A

BUTTON A

BUTTON B

B

BUTTON C

C

D

BUTTON D

14

A

I

O

2

1

4

1

C

DB

3

O

I

2

PAIRING THE TRANSMITTER AND VEHICLE

You must pair the transmitter with the vehicle before you can control it. FIRST SWITCH ON THE VEHICLE, THEN IMMEDIATELY SWITCH ON THE
TRANSMITTER. The transmitter’s red LED changes from a flashing light to off when pairing is complete. If the red LED does not stop flashing
after around 10 seconds, switch off the transmitter and vehicle, then try again.

O

I

I

O

CONSUMER INFORMATION

Note to Adults: To ensure that the child’s play is both safe and fun, please review all operating
instructions and safety rules with your child.

• NEVER drive your vehicle on streets! Streets are for real cars!

• DO NOT pick up the vehicle while it is in motion.

• The toy is not intended for children under 8 years old.

• Keep fingers, hair and loose clothing away from the wheels while the
vehicle is switched ON.

• Never disassemble or attempt to modify the vehicle.

• Operating range of transmitter is around 65 feet (20 meters).

• When not in use, turn off the vehicle and transmitter. To avoid
accidental operation, remove all batteries.

• If the vehicle and/or transmitter are wet, thoroughly dry before next use.

• Regularly examine all wires and connectors. In the event of damage,
do not use.

LET’S GET STARTED!

™

FIRST OFF, YOU MUST CHARGE THE 9.6V TYCO

CAUTION: Use only the charger supplied with this toy. Do not use any other charging source.

1. Plug wall pack charger into standard wall outlet.

2. Connect the wires leading from the battery pack to
the wall pack charger connector. Make certain the
two connectors are tightly snapped together.

3. A red LED will light up to indicate the battery pack
is charging. When a green LED lights up, that
means charging is complete.

4. To disconnect wires, push down on the connector
clip and pull apart.

5. Your battery pack consists of new parts and
materials; therefore, you should charge the battery
pack for 5-1/2 hours the first two times you charge
the battery. Subsequent charges will require only
4 hours.

6. After charging, the battery will feel warm. This

7. Charging the battery pack for more than what is

8. Unlike alkaline batteries, where the power loss is

9. After use, the battery pack will be hot! Wait at least

RC BATTERY PACK. FOLLOW THESE INSTRUCTIONS:

condition is normal for fully charged batteries.

recommended will not give you a longer running time.

gradual, a NiMH battery will run for its normal
running time, depending on your particular vehicle,
and then lose most of its power at once. It is now
time to recharge the battery pack.

20 minutes until the battery pack cools before
recharging. Recharging a warm or hot battery pack
will greatly reduce the number of times your
battery pack can be recharged.

NOTE: When playing with multiple vehicles, each must be paired one at a time. A maximum of 6 vehicles can be
paired in one location.

OPERATIONS

FORWARD / CLIMBING

A

TURN LEFT

C

C

FLIP OVER / REVERSE

B

D

TURN RIGHT

A

BATTERY INSTALLATION

Requires a 9.6V TYCO™ RC (NiMH) battery pack for the vehicle and 2 AA (LR6) alkaline batteries
for the transmitter. For longer life, use alkaline batteries. Dispose of batteries safely.

VEHICLE

1. First turn the Terra Climber
down as shown.

2. Unscrew the battery cover with a Phillips
head screwdriver (not included).

3. Hold the TYCO
(included) with the labels facing up as
shown. Insert the battery connector into
the vehicle battery connector as shown.

4. Replace the battery cover and tighten screws.

NOTE: If vehicle malfunctions, remove and
re-install the batteries. This should reset your
vehicle and let you resume normal operation.

™

RC 9.6V battery pack

™

vehicle upside

TRANSMITTER

1. Remove the battery cover as shown.

2. Install 2 AA Carbon-Zinc batteries
(included) with polarity (+/-) as shown
inside the battery compartment.

3. Replace the battery cover.

4. For best performance, use alkaline batteries.

SPIN LEFT

B

NOTES

• For best performance, play on concrete or asphalt surfaces.

• Keep wheels clean. A buildup of dirt or dust might affect the climbing performance of the vehicle.

C

SPIN RIGHT

A

32

D