Keep these instructions for future reference as they contain
important information. IMPORTANT: Please read all
“Consumer Information” before operating your vehicle.
CAUTION:
Surfaces may become hot and cause
burns if electronics get wet. Do not operate vehicle
through water or snow.
CAUTION:
To prevent entanglement, keep all hair
away from the wheels.
1
Forward
2
Reverse left
3
Battery cover
4
ON(I) / OFF(O)
W5748 TUMBLER
W5749 BAT-POD X3723 THE BAT
This set includes: 1 vehicle, 1 transmitter, 1 antenna tube.
I. CONTENTS/ FEATURES
Asst.W5747
W5748/W5749/X3723-0920
3+
®
A. Insert fl exible antenna wire through
antenna tube, then insert end of tube
fi rmly into transmitter hole.
B. Tie a knot at the end of the fl exible
antenna wire to keep the tube in place.
Antenna tube
1
2
3
3
3
3
4
4
4
O
I
O
I
O
I
II. BATTERY INSTALLATION
(Transmitter & Vehicle)
Requires 2 AAA alkaline batteries for the vehicle and 2 AA
alkaline batteries for the transmitter. Batteries not included.
Vehicle
1. Unscrew the battery cover with a Phillips head
screwdriver (not included).
2. Your vehicle requires 2 AAA alkaline batteries.
Install with polarity (+/-) as shown inside the
battery compartment.
3. Replace battery cover and tighten screw.
Transmitter
1. Remove battery cover as shown.
2. Transmitter requires 2 AA alkaline batteries. Install with
polarity (+/-) as shown inside the battery compartment.
3. Replace battery cover and push shut.
NOTE: Once the batteries are installed the transmitter
will always be “ON” and will work automatically the
moment you use it.
III. OPERATION
FORWARD REVERSE LEFT
2 x AAA
2 x AA
2 x AAA
Loading...