Mattel WD465, T9542, W0464, X1445 User Manual
NITRO SPEEDERS ™
Keep these instructions for future reference as they contain
important information. IMPORTANT: Please read all
“Consumer Information” before operating your vehicle.
8+
Asst. T9541
T9542/X1445/W0464/W0465-0920
®
CAUTION:
To prevent entanglement, keep all hair
away from the wheels.
I. CONTENTS/ FEATURES
This set includes: 1 Vehicle, 1 Transmitter
1
Forward / Reverse
2
Left / Right
3
Battery cover
4
ON (I) / OFF (0)
5
CHARGER ( ) / OFF (0) / ON (I)
6
Steering adjuster button - Adjust, if necessary, to keep
vehicle running straight.
7
Red LED
8
Green LED
NOTE:
Vehicle powered by permanently installed Li-Po battery
and transmitter requires 4 AA alkaline batteries, not
included.
For hassle-free racing, each vehicle has a designated
racing channel (Camaro® "A" / Fiesta "B" / Mustang "C").
To race your friends, choose two vehicles with different
channel designations.
PLEASE NOTE: Vehicles running on the same channel
cannot race together.
7
1
6
3
CAUTION:
Surfaces may become hot and cause
burns if electronics get wet. Do not operate vehicle
through water or snow.
W0464 Chevy® Camaro
®
4
A
O I
W0465 Ken Block Ford Fiesta
4
B
O I
T9542 / X1445 Ford Mustang GT
C
4
O I
8
2
NOTE: If tires detach, simply line
up the hole in the tire with the
wheel base and push the tire back
into place to continue play.
5
3
II. BATTERY INSTALLATION
(Transmitter)
Requires 4 AA alkaline batteries for the
transmitter, not included.
Transmitter
1. Unscrew the battery cover with a Phillips head
screwdriver (not included).
2. Install 4 AA alkaline batteries with polarity (+/-) as
shown inside the battery compartment.
3. Replace battery covers and tighten screws.
III. CHARGING THE VEHICLE
Your vehicle is powered by a Li-Po battery that is
permanently installed. The vehicle must be charged before
play. To charge, first make sure you have installed 4 AA
alkaline batteries in the transmitter as shown in Section II.
Then follow these easy steps.
1. Make sure the switch on both the transmitter and
vehicle are in the OFF position.
2. Open door on transmitter, hold plug and pull out
charger cable (See ).
3. Connect plug to vehicle. Make sure the connection is
secure (See ).
4. To begin charging, move the switch on the transmitter
from OFF to CHARGER. Both the Red and Green LEDs
light up when charging (See ).
5. The charging process takes up to 25 minutes. Green
LED goes off when charging is complete.
6. When fully charged, remove the charger cable from the
vehicle.
a
b
c
IV. OPERATION
Infra-red LED in Transmitter needs to point towards
vehicle during play. If your vehicle doesn't respond when
the Transmitter is activated, make sure the LEDs are
pointing at the vehicle.
Turn vehicle and
transmitter ON to play.
Bottom view
TIP: Always hold the plug when disconnecting.
NEVER pull on the cable to disconnect; this may
cause the cable to break.
a
b c
IMPORTANT:
• Do not cover up the infra-red LEDs with your fingers.
• Works best on flat, level, hard surfaces.
• This product is not recommended for use on carpet,
loose dirt or wet surfaces.
Bottom view
FORWARD
REVERSE
FORWARD LEFT
Infra-red
LED
FORWARD RIGHT
REVERSE RIGHTREVERSE LEFT
Loading...