Mattel DARING DERAIL SET, FBK07 Instructions Manual
D
D
D
D
TM
TM
Keep these instructions for future reference as they contain important information.
ARING
ARING
ARING
ARING
INSTRUCTIONS
D
D
D
D
ERAIL
ERAIL
ERAIL
ERAIL
WHAT’S INCLUDEDWHAT’S INCLUDED
S
S
S
S
ET
ET
ET
ET
YS
TRS
X1
X1
BS1
X1
TU2
X1
X1
S8
X1
X1
S2
X1
X1
CS
HELPFUL HINTSHELPFUL HINTS
X8
X1X1
X2
X1
X1
X1X1X1X1
CS
Note: Some engines may not work on this track set.
Track marking codes are found on the bottom of tracks.
ADULT ASSEMBLY REQUIRED.
No tools needed.
ASSEMBLYASSEMBLY
TU2
21
3
CS
4 5
6
BATTERY INFORMATIONBATTERY INFORMATION
BATTERY INSTALLATION
Access the battery compartment by unscrewing and separating the top half of the engine from the bottom half of the engine. Install the batteries as indicated
inside the battery compartment. Re-assemble the two halves of the engine, re-insert the screw and tighten. If the product begins to malfunction, check the
battery installation. You may need to reset the electronics by removing the batteries and reinstalling them. If the product continues to malfunction or no longer
operates, remove the batteries from the toy and replace them with fresh batteries. Requires 2 “AAA” (LR03) batteries.
Required tool: Phillips screwdriver (not included)
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of batteries safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
7
1,5V x 2
“AAA” (LR03)
Set the stop-track to “stop”. Use the switch-track to control
Connect and set the bridge, and push the flame down.
4 5
Loading...