Page 1
INSTRUCTION SHEET
SPECIFICATIONS
Asst:
INSTRUCTIONS
INSTRUCTIONS
CONTENTS
CLD91
6+
Toy No.:
Part No.:
Lang. Code:
Trim Size:
Folded Size:
Type of Fold:
#colors:
Colors:
Paper Stork:
Paper Weight:
EDM No.:
Please remove everything from the package and compare to the
contents shown here. If any items are missing, please contact your
local Mattel office. Keep these instructions for future reference as
they contain important information.
The product may stain fabrics and other surfaces. Avoid contact with
carpet, clothing,
Requires 4 AA(LR6) alkaline batteries (not included).
walls and furniture. Protect play area before use.
©2014 Mattel. All Rights Reserved.
Page 2
SETUP
BATTERY INSTALLATION
•
Unscrew the baery cover with
a Phillips head screwdriver
(not
included).
•
Install 4 AA alkaline baeries
(not included) in the orientation (+/-)
as shown.
•
Replace baery cover
and tighten screws.
• When exposed to an electrostatic
source, the product may malfunction.
To resume normal operation,
remove and re-install the baeries.
Remove cap. Insert pen into the airbrush until it clicks into place.
Align dial to start position.
Turn power switch ON (
I).
ASSEMBLY
FOR LEFT-HANDEDFOR RIGHT-HANDED
1
2
3
3
1 2
Page 3
SETUP
Use a piece of paper (not included) to test the spray. Pull trigger
4
and spray ink between 0.25 and 0.5 inches (0.6cm to 1.3cm) from paper.
Adjust the dial one click at a time until the spray is visible.
Remove cap. Insert pen into the airbrush until it clicks into place.
1
CLICK
Align dial to start position.
2
3
Turn power switch ON (
I).
A B
If lile or no ink comes out,
turn dial one click in the
direction of the arrow on the
airbrush and test the spray
again. Repeat until spray is
visible.
You must re-adjust the dial every time a pen is loaded.
To prevent ink from drying, recap pens aer use and replace
in holder, cap side down.
Page 4
CLICK
Use a piece of paper (not included) to test the spray. Pull trigger
4
and spray ink between 0.25 and 0.5 inches (0.6cm to 1.3cm) from paper.
Adjust the dial one click at a time until the spray is visible.
A B
If lile or no ink comes out,
turn dial one click in the
direction of the arrow on the
airbrush and test the spray
again. Repeat until spray is
visible.
You must re-adjust the dial every time a pen is loaded.
To prevent ink from drying, recap pens aer use and replace
in holder, cap side down.
If ink foams at the tip, turn
dial one click back towards
the starting position.
Clean any foam with a
disposable cloth (not included)
and test spray again.
Repeat until spray no
longer foams.
Note:
Page 5
TIPS
CLEAN UP
•
While spraying, point nozzle straight down so it is perpendicular to the fashion.
•
Be careful not to spray into your face or the face of others.
•
Keep nozzle clean by wiping occasionally during use or when there is ink build-up.
• Always keep pens stored cap side down in holder.
• Only use the supplied pens and fashions. Pens are made to apply to included
washable fabric fashions only.
• For more information go online: www.Barbie.com/ToyTips
• For best results wash fashions in warm water with soap (not included). To avoid
burns do not use water that is too hot, above 120°F (49°C).
• Wipe the plastic pieces clean with a damp cloth (not included).
• Do not immerse the airbrush and markers in water.
• The fashions and stencils provided are reusable and washable.
• Rinse, clean and dry all items thoroughly before storing.
TROUBLESHOOTING
DESIGN
Hold airbrush between 0.25 and 0.5
inches (0.6cm to 1.3cm) away from
fashion, then pull trigger to spray.
Hang stencil over the fashion.
Hang dress form on the
cra station.
Apply a fashion to the
dress form.
If you have difficulty geing the airbrush to spray:
• Ensure the dial is properly adjusted. See SETUP, Step 4.
• Check that the marker has not run-out or dry.
• Check that the marker is clicked into place.
• Ensure the airbrush nozzle is clear.
• Replace the baeries.
CLD91-0970-1100387811-DOM
Mattel Australia Pty., Ltd., Richmond, Victoria. 3121.Consumer Advisory Service - 1300 135
312. Mattel East Asia Ltd., Room 503-09, North Tower, World Finance Centre, Harbour City,
Tsimshatsui, HK, China. Tel.: (852) 3185-6500. Diimport & Diedarkan Oleh: Mattel Southeast
Asia Pte. Ltd. , No 19-1, Tower 3 Avenue 7, Bangsar South City, No 8, Jalan Kerinchi, 59200
Kuala Lumpur, Malaysia. Tel: 03-78803817, Fax: 03-78803867.
CONSUMER INFORMATION
SERVICE.MATTEL.COM
Need Assistance? Visit service.mattel.com or call 1-800-524-8697
(US and Canada only).
Wash and dry fashion, then design again.
1
2
4
OR
Spray without a stencil.
Place stencil over the fashion
for a freestyle design.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product.
To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
Protect the environment by not disposing of this product with household waste [2002/96/EC].
Check your local authority for recycling advice and facilities.
√
x
3
Page 6
CLEAN UP
• For best results wash fashions in warm water with soap (not included). To avoid
burns do not use water that is too hot, above 120°F (49°C).
• Wipe the plastic pieces clean with a damp cloth (not included).
• Do not immerse the airbrush and markers in water.
• The fashions and stencils provided are reusable and washable.
• Rinse, clean and dry all items thoroughly before storing.
TIPS
•
While spraying, point nozzle straight down so it is perpendicular to the fashion.
•
Be careful not to spray into your face or the face of others.
•
Keep nozzle clean by wiping occasionally during use or when there is ink build-up.
• Always keep pens stored cap side down in holder.
• Only use the supplied pens and fashions. Pens are made to apply to included
washable fabric fashions only.
• For more information go online: www.Barbie.com/ToyTips
TROUBLESHOOTING
If you have difficulty geing the airbrush to spray:
• Ensure the dial is properly adjusted. See SETUP, Step 4.
• Check that the marker has not run-out or dry.
• Check that the marker is clicked into place.
• Ensure the airbrush nozzle is clear.
• Replace the baeries.
INSTRUCTIONS
INSTRUCTIONS
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product.
To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
Protect the environment by not disposing of this product with household waste [2002/96/EC].
Check your local authority for recycling advice and facilities.
CLD91-0970-1100387811-DOM
CONSUMER INFORMATION
Need Assistance? Visit service.mattel.com or call 1-800-524-8697
SERVICE.MATTEL.COM
Mattel Australia Pty., Ltd., Richmond, Victoria. 3121.Consumer Advisory Service - 1300 135
312. Mattel East Asia Ltd., Room 503-09, North Tower, World Finance Centre, Harbour City,
Tsimshatsui, HK, China. Tel.: (852) 3185-6500. Diimport & Diedarkan Oleh: Mattel Southeast
Asia Pte. Ltd. , No 19-1, Tower 3 Avenue 7, Bangsar South City, No 8, Jalan Kerinchi, 59200
Kuala Lumpur, Malaysia. Tel: 03-78803817, Fax: 03-78803867.
(US and Canada only).
Mattel, Inc., 636 Girard Avenue,
East Aurora, NY 14052, U.S.A.
Consumer Services
1-800-524-8697.
Mattel U.K. Ltd., Vanwall
Business Park, Maidenhead SL6
4UB. Helpline 01628 500303.
Please remove everything from the package and compare to the
contents shown here. If any items are missing, please contact your
local Mattel office. Keep these instructions for future reference as
they contain important information.
The product may stain fabrics and other surfaces. Avoid contact with
carpet, clothing,
walls and furniture. Protect play area before use.
Requires 4 AA(LR6) alkaline batteries (not included).
©2014 Mattel. All Rights Reserved.
Loading...