MATELEC AUSTRALIA. P 1800 281 282. F 1300 281 282
INFO@MATELECAUSTRALIA.COM.AU. WWW.MATELECAUSTRALIA.COM.AU
SUMMARY
The FMS - 12051 Motion sensor is a surface mount ceiling sensor, and utilises infrared technology to detect
and identify motion, night and day.
Upon detection, the connected lighting load will illuminate for a user determined period of time.
SPECIFICATIONS
Power Source: 220V - 240VAC
Power Frequency: 50HZ
Ambient Height: 3 - 2000 LUX (adjustable)
Time delay: Min 10 seconds
Max 7 minutes
Rated Load: 1200W (Incandescent)
300W (Fluro)
Detection distance: 12m max
Detection range: 180°
Installation height: 1.8m - 2.5m
Manual Override: No
Weatherproof Rating: IP44
Warranty: 1 year
INSTALLATION
Note: All electrical connections relating to this installation must be carried out by a suitably qualied and
registered electrician.
The sensor should not be installed outside.
FMS-12051 MOTION SENSOR INSTRUCTIONS
Fig.1
SET UP AND ADJUSTMENT
1. Adjust the TIME setting anti clockwise to minimum (10s)
2. Adjust the LUX setting clockwise to maximum.
3. Switch the power on. (The control load will not work immediately, as it requires 5-30 seconds to
preheat.
4. The sensor will activate again, 5 - 15 seconds later, once the rst switching cycle is completed.
5. If testing when the ambient light is greater than 3 LUX, the initial switch cycle will not continue to
operate. In this instance, cover the detection window with a dark object, such as a cloth. It is normal
for the cycle to stop within 5-15 seconds of completion of the initial signal.
PROBLEM POSSIBLE SOLUTION
Lights do not turn on
Check the power is on
Check the bulbs and xtures are working correctly
Check wiring is correct
Ensure LUX setting is set for a darker setting than present
Lights do not switch off
Make sure unit is wired correctly.
Ensure there is not a continuous signal in the detection eld.
Ensure the time delay is set on the appropriate setting.
Lights do not switch on
Make sure there are no reective sources in the detection eld
Check detection window is clear
Check installation height and detection distance is in the
parameters.
TROUBLESHOOTING
WIRING DIAGRAM
As with all PIR motion sensors, the FMS - 12051 must be positioned away from any sources of heat (such as
extractor fans, dryers, any air conditioning or heating registers, etc.) Reective surfaces and overhanging
branches may also cause false activation.
1. Isolate the power
2. Select a suitable location to install the unit by considering points in previous sections and the units
detection range and direction
3. Remove the housing cover by loosening the two screws. (Fig 1)
4. Place the back housing cover onto the surface and mark the position of the mounting holes.
5. Drill the holes and insert wall plugs into these holes, and x back housing cover to surface.
LN
L(BROWN)
LOAD
IN ~
N(BLUE)
A(RED)
MATELEC AUSTRALIA. P 1800 281 282. F 1300 281 282
INFO@MATELECAUSTRALIA.COM.AU. WWW.MATELECAUSTRALIA.COM.AU
Loading...