Three - Phase Four - Wire meter
• User Manual for FKW 15120
www.matelecaustralia.com.au
1. Introduction
This is a three phase seven module 100A meter,
2. Technical
2.1 Technical Parameters
Voltage: 3*230/400V
Current: 0.25-10(100) A
Standard: EN50470-1/3
Frequency: 50Hz
Impulse constant: 1000imp/kWh
Display: LCD 6+1
Power consumption: ≤2W ＜10VA
Temperature range: -25~55℃
Average humidity value of year: ≤95%
www.matelecaustralia.com.au
1
1
3. Description
A Power Indication of Phase A
B Power Indication of Phase B
C Power Indication of Phase C
D Pulse Output
B
A
C
D
Phase Lights
Solid light = Normal power consumption
Flash light = Small power consumption
No light = No power consumption
aterial
M
Case Grey flame resistant ABS
Terminal cover Grey flame resistant ABS
Base Bottom Grey flame resistant ABS
4. Display
www.matelecaustralia.com.au
2
5. Connection Diagram
Note: 9 and 8 are for impulse output, used for remote power monitoring.
6. Meter Dimensions
Height 100mm
Width 122mm
Depth 65mm
Weight 0.3796kg(Net)
www.matelecaustralia.com.au
3
* Connect according to the wiring diagram, See Fig 1;
Fig. 1
7. Safety Instructions
Information for Your Own S afety
This manual does not contain all of the safety measures for operation, however, it does contain
information which must be adhered to for your own personal safety and to avoid damage to the
equipment. This information is highlighted by a warning triangle with an exclamation mark or a
lightning bolt depending on the severity of the warning.
Warning
Means that failure to observe the instruction can result in death, serious injury or considerable
material damage.
Caution
Means hazard of electric shock and failure to take the necessary safety precautions will result in
death, serious injury or considerable material damage.
www.matelecaustralia.com.au
4
Qualified personel
Installation and operation of this equipment described in this manual may only be
performed by a suitably qualified person. Only people that are authorized to install,
connect and use this equipment circuits and can do so according to safety and
regulatory standards are considered qualified personnel in the manual.
Exclusion of liability
We have checked the contents of this publication and every effort has been made to
ensure that the descriptions are as accurate as possible. The data in this manual is
checked regularly and the necessary corrections will be included in the subsequent
editions.
Subject to technical modifications without notice.
General Warning
After removing the packaging make sure the integrity of the unit. If in doubt don't use the
equipment and contact the supplier where the product was purchased. Mounting of electric
appliances must be carried out only by suitably qualified electricians. It is imperative to observe
the generally applicable safety measures.
In case of failure and /or malfunctioning of the device, turn off. For any repair please contact the
supplier where the product was purchased. Failure to comply with the above may compromise
the device Safety.
Warranty
The manufacturer will repair or exchange the products where the lead seal is still intact, within 12
months, if the product is found to have a manufacturing defect.
Technical support
For any problems of our products please contact:
8 Telford Drive
Shepparton 3630
VICTORIA, AUSTRALIA
www.matelecaustralia.com.au
www.matelecaustralia.com.au
5
Loading...