Matchbox TREASURE TRACK Instructions Manual

IMPORTANT:

• Readjust dial if needed when moving your search to a new location.

• The truck may not ﬁnd metal objects correctly in certain environments where there is a high concentration of metal in the sand/soil, such as in desert sand and some topsoils.

• If all steps are followed and truck is continuously ﬂashing red and detection sounds are heard, move to a different search area.

For push around play, fold up antenna loop and press button on truck cab for lights and sounds.

• No metal detection in this mode.

• Larger metal objects can be found at deeper depths.

• Do not leave the truck outdoors in sun or rain.

• Do not carry the truck by the antenna loop as this will cause damage.

• Do not use the antenna loop as a shovel.

• Do not bury the truck in sand.

• Avoid playing on wet surfaces or in water.

• Shake sand off and use a soft cloth to wipe the truck clean.

• Scooper can be rinsed and immersed in water.

• Do not rinse or immerse the truck in water.

• Do not use chemicals to clean the truck.

Pinpointing takes practice and is helpful to locate the buried treasure.

1. When detection occurs, continue sweeping the antenna loop over the target area with a continuous side to side motion to gradually narrow down the search area.

2. Detected metal objects can be located under the truck’s antenna loop or very close to it.

LOW SENSITIVITY HIGH SENSITIVITY

1 2

6 8

BATTERY SAFETY INFORMATION

In exceptional circumstances batteries may leak ﬂuids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the product before being charged.

• Rechargeable batteries are only to be charged under adult supervision.

• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.

• Do not mix old and new batteries.

• Only batteries of the same or equivalent type as recommended are to be used.

• Batteries are to be inserted with the correct polarity.

• Exhausted batteries are to be removed from the product.

• The supply terminals are not to be short-circuited.

• Dispose of battery(ies) safely.

• Do not dispose of this product in a ﬁre. The batteries inside may explode or leak.

Includes 4 AA (R6) carbon-zinc batteries for demonstration purposes only. Replace the batteries if truck begins to malfunction. Unscrew the battery cover with a Phillips head screwdriver (not included). Remove batteries and dispose of them safely. Install 4 new AA (LR6) Alkaline batteries in the orientation (+/-) shown. Replace battery cover and tighten screw. For longer life, use alkaline batteries. When exposed to an electrostatic source, the product may malfunction. To resume normal operation, remove and re-install the batteries.

©2015 Mattel. All Rights Reserved. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Services 1-800-524-8697. Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline 01628 500303. Mattel Australia Pty., Ltd., Richmond, Victoria.

3121.Consumer Advisory Service - 1300 135 312. Mattel East Asia

Ltd., Room 503-09, North Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China. Tel.: (852) 3185-6500. Diimport & Diedarkan Oleh: Mattel Southeast Asia Pte. Ltd. , No 19-1, Tower 3 Avenue 7, Bangsar South City, No 8, Jalan Kerinchi, 59200 Kuala Lumpur, Malaysia. Tel: 03-78803817, Fax: 03-78803867.

PLEASE KEEP THESE INSTRUCTIONS FOR

FUTURE REFERENCE AS THEY CONTAIN

IMPORTANT INFORMATION.

CONTENTS / FEATURES

INSTRUCTIONS

BUTTON

Use it to activate lights/sounds, metal detector & adjust volume.

SCOOPER

Use it to dig and sift for treasure/metallic objects.

SENSITIVITY CONTROL DIAL

Use it to adjust how sensitive the antenna loop is to metallic objects.

ANTENNA LOOP

Use it to search for treasure/metallic objects.

Place truck on non-metal play surface, ﬂip down antenna loop and adjust dial for sensitivity*.

*If detector is continuously blinking red with detection

sounds, adjust sensitivity knob until red light stops blinking. See Step 7 for further details on adjusting metal detector for optimal play.

Remove scooper and dig in detected area!

1. Push the truck around and sweep the search area continuously. Truck’s green light will ﬂash and seeking sounds will be heard.

• Note: Truck must have continuous movement in order to

detect objects.

• Truck will enter sleep mode after approximately 60 seconds.

Press button on truck cab to reactivate.

2. Red light will ﬂash and detection sounds will be heard when metal is detected*.

*See Step 8 for further details on accurate pinpointing in suspected detection areas.

Grab a map & hunt for adventure with the

Matchbox® Treasure Truck™! The hunt is on!

SERVICE.MATTEL.COM

DISCOVER

TRUCK MODE

VOLUME CONTROL

PINPOINTING

HELPFUL HINTS

CLEAN UP

BATTERY REPLACEMENT

ADJUSTMENT

DIG

DETECT

TURN ON & ADJUST

Dig & sift until treasure is found! Snap scooper back onto truck.

This is a battery-operated product. 1 FCC flyer (00007-1849G7) is required to be placed inside the packaging.

Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities.

For optimal play, place the truck on the play surface, away from metal objects. Turn the sensitivity control dial clockwise until red light ﬂashes and detection sounds are heard. Then slowly turn the dial counter-clockwise until red light stops ﬂashing. Stop when the green light ﬂashes and seeking sounds are heard.

Press and hold button to toggle through volume levels. Release button when desired volume is heard.

DJH50-0970

1100766595-DOM

™