Page 1
Sandwich Salad Unit
Undercounter Refrigerator, Freezer
Installation and Operation Manual
Please read this manual completely before attempting to install or operate this equipment!
Full Stainless Steel Visible Exterior
SPT-28, SPT-48, SPT-72
UC-28SR, UC-48DR, UC-72TR
Page 2
1. SPECIFICATION
..........................................................................................
2
2. SERIAL NUMBER
........................................................................................
2
3. INSTALLATION OF HANDLE....................................................................... 3
4.
INSTALLATION OF CASTORS
....................................................................... 3
5. HOW TO CLEAN THE PAN SUPPORTER .................................................. 4
6. INSTALLATION
.............................................................................................
5
7. CLEANING & CAUTION
...............................................................................
6
8. BASIC OPERATION
.....................................................................................
7
9. BEFORE REQUESTING SERVICE
.............................................................
8
10. WARRANTY
.........................................................................................
9~11
Sandwich Salad Unit
2
Master bilt
CONTENTS
SPECIFICATION
PAGE
MODEL COMP H.P. V/Hz REFRIGERANT AMPS WEIGHT
SPT-48 1/3 115V/60Hz R-134a 5.0A 180lbs
SPT-28 1/4 115V/60Hz R-134a 5.5A 128lbs
SPT-72 5/8 115V/60Hz R-134a 10.8A 385lbs
The serial number is located on the rating label which is on the left interior
wall.
Please retain the unit’s serial number for service purpose.
SERIAL NUMBER
Undercounter Refrigerator
MODEL COMP H.P. V/Hz REFRIGERANT AMPS WEIGHT
UC-48DR 1/5 115V/60Hz R-134a 4.0A 168lbs
UC-28SR 1/5 115V/60Hz R-134a 4.0A 118lbs
UC-72TR 1/3 115V/60Hz R-134a 7.0A 340lbs
Page 3
3
Master bilt
1. Raise the COVER TOP as shown below.
2. Attach the HANDLE to the COVER TOP with screws included.
3. There are Handle and Screws in the attached Castor Box.
3. INSTALLATION OF HANDLE
1) Screw the castor (in rear side) and the castor brakes (in front side) by using
castor wrench.
2) Use the castor shims to level the cabinet, if necessary, by inserting them to
stems of the castors.
COVER CABINET *TOP
DOOR
ROTATION
CASTOR (WITH BRAKE)(2EA)
CASTOR(2EA)
CABINET
WASHER
BOLT
HANDLE
LID
4. INSTALLATION OF CASTOR AND CAST OR BRAKE
Page 4
4
Master bilt
5. HO W T O CLEAN THE PAN SUPPOR TER
Drain Pan
Pan
Guide Pan
Pan Supporter
1) Remove the Guide Pans and Pans. Then pull out the Pan Suppor ter. Clean
the pan supporter and reinstall in place.
MODEL: SPT-28 SPT-48 SPT-72
Page 5
5
Master bilt
1. GOOD AIR CIRCULATION
- Be sure to avoid an y object which may stop the air flo w.
- Be sure that there is ample air space so that air can flow through the rear of the unit.
- Turbo Air recommends that the rear of the unit be no less than 5 inches from the wall.
2. PLACE ON STR ONG GROUND
- Be sure the location chosen has a strong enough floor to suppor t the total weight of
the cabinet and any other contents.
3. DO NOT PLA CE NEAR HEAT
- Be sure to avoid hot corners and locations near stoves .
- High ambient temperature will make much lower cooling efficiency.
4. INDOOR USAGE ONLY
- Be sure to install this unit indoor.
- So, it should prohibit getting wet from the rain.
5. STABILIZING
- Make sure the unit is installed in a stable condition with the front wheels lock ed
while in use.
6. LEVELING
- Be sure that the unit is level from front to bac k and side to side.
INSTALLATION
Page 6
6
Master bilt
CLEANING
1. CLEANING THE INTERIOR AND EXTERIOR
- The interior and exterior of the unit can be cleaned using warm water with soap.
- Do not use an abrasive cleaner because it will scratch the surf ace.
2. CLEANING THE CONDENSER FINS
- To maintain proper refrigeration performace, the Condenser coil must be free of dust,
dirt, and grease.
This will require periodic cleaning. Condenser fins should be cleaned at least every
three months (90 days) or as needed.
3. CLEAN THE GASKET
- The door gasket should be cleaned frequently to maintain proper sealing.
4. CHECK AFTER CLEANING
- Check the unit again for saf ety.
- Check that the unit is operating properly.
1. POWER CORD
- Be sure the power cord is connected to the proper voltage.
- A protected circuit of the correct voltage and amperage must be run for connection of
the line cord.
- Turn ‘off’ the power switch before disconnecting the power cord, whenever performing
maintenance functions or cleaning the refrigerated cabinet.
- Compressor warranties are void if compressor b urns out due to low voltage .
2. RE-STARTING
- If disconnected, wait 5 minutes before re-starting.
CA UTION
Page 7
SPT-28, SPT-48, SPT-72
UC-28SR, UC-48DR, UC-72TR
1. The controller(thermostat) is located at the top inside of the unit.
2. The factory setting for the control is ‘Normal’.
3. Setting toward “Cool” for higher temperature and “Cold” f or low er temperature.
4. The thermostat controls compressor’s on/off b y sensing inside temperature.
7
Master bilt
BASIC OPERATION
COLD
OFF
NORMAL
COOL
UC-28SR
COLD
OFF
NORMAL
COOL
UC-48DR
COLD
OFF
NORMAL
COOL
SPT-28
COLD
OFF
NORMAL
COOL
SPT-48
COLD
OFF
NORMAL
COOL
UC-72TR
SPT-72
Page 8
8
Master bilt
BEFORE REQUESTING SER VICE
SYMPTOMS CAUSES SOLUTIONS
Refrigerator(Freezer)
is frozer .
The unit does not
refrigerate at all.
The unit does not
refrigerate well.
There is a loud noise.
There are dew-drops
on the unit exterior .
There are dew-drops
on the unit interior .
The door does not
close tightly.
• The setting temperature is too
low(high) to maintain food
freshness.
• There is a power connection
failure problem.
• The unit is in sunlight or near a
heating device.
• The unit contains hot f ood or too
much food.
• The unit door is opened too
frequently or left open too long.
• The temp . dial is not on the
correct position.
• The condenser is clogged.
• The floor is too weak or the
leveling f eet are set incorrectly.
• The backside of the unit is too
close to the wall.
• The tra y is not in the correct
position.
• High-moisture air can produce
dewdrops during rainy seasons.
• The door is opened too
frequently or left open too long.
• Damp f ood is stored.
• The door is bent.
• The unit is not le vel.
• The door gasket has come out.
• Turn the temperature dial to a
warmer(colder) setting.
•
Check the power cord to mak e sure
the unit is pluged in it correctly
.
• Mov e out of sunlight or a wa y
from heater.
• Check the condition of stored
food.
• Check the position of the temp
control dial.
• Check the installation and
adjust the tray position.
• Wipe with a dry cloth.
• K eep the door closed to
remove de wdrops.
• Le vel the unit again.
• Reposition the gasket.
The following points are not malfunctions:
• A water-flowing sound can be heard when the compressor stops.
This is the sound of REFRIGERANT flowing.
• The compressor does not run during the defrost cycle.
Page 9
9
Master bilt
Warranty Claims
All claims for labor or parts must be made directly through Turbo Air. If unit was manufactured more than one year,
proof of purchase must be faxed in or sent with claim. All claims should include: model number of the unit, the serial
number of the cabinet, and all pertinent information supporting the existence of the alleged defect.
If compressor is replaced under warranty, Turbo Air will either request the compressor or compressor tag be returned.
Compressor or tag must be returned with all information related to the unit. Any action or breach of these warranty
provisions must be commenced within one year after said cause of action has occurred.
One Year Parts & Labor Warranty
Turbo Air warrants to the original purchaser of every new Turbo Air refrigerated unit, the cabinet and all parts thereof,
to be free from defects in material or workmanship, under normal and proper use and maintenance service as
specified by Turbo Air and upon proper installation and start-up in accordance with the instruction packet supplied
with each Turbo Air unit. Turbo Air’s obligation under this warranty is limited to a period of one (1) year from the date
of original installation or 15 months after shipment date from Turbo Air, whichever occurs first.
Any parts, covered under this warranty, that are determined by Turbo Air to have been defective within one (1) year
of original installation or fifteen (15) months after shipment date from manufacturer, whichever occurs first, is limited to
the repair or replacement, including labor charges, of defective parts or assemblies. The labor warranty shall include
standard straight time labor charges only and reasonable travel time, as determined by Turbo Air.
Additional Four Year Compressor Warranty
In addition to the one (1) year warranty stated above, Turbo Air warrants its hermetically sealed compressor to be free
from defects in both material and workmanship under normal and proper use and maintenance service for a period of
four (4) additional years from the date of original installation, but not to exceed five (5) years and three (3) months
after shipment from the manufacturer.
Compressor determined by Turbo Air to have been defective within this extended period will, at Turbo Air’s option, be
either repaired or replaced with a compressor or compressor parts of similar design and capacity.
The four (4) year extended compressor warranty applies only to hermetically sealed parts of the compressor and
does not apply to any other parts or components, including, but not limited to, cabinet, paint finish, temperature
control, refrigerant, metering device, driers, motor starting equipment, fan assembly or and other electrical
component, etcetera.
404A / 134A Compressor Warranty
The four-year compressor warranty detailed above will be voided if the following procedure is not carefully adhered to:
1. This system contains R404A or R134A refrigerant and polyolester lubricant. The polyol ester lubricant has
rapid moisture absorbing qualities.
2. Drier replacement is very important and must be changed when a system is opened for servicing. A 620
copper drier or better is highly recommended.
3. Micron level vacuums must be achieved to insure low moisture levels in the system. 500 microns or lower
must be obtained.
4. When compressor is grounded, suction filter drier and 620 drier or better must be replaced.
5. Compressor must be obtained through Turbo Air Inc., unless otherwise specified in writing, through Turbo
Air’s warranty department.
Warranty
Page 10
10
Master bilt
What Is Not Covered By This W arranty
Turbo Air’s sole obligation under this warranty is limited to either repair or replacement of parts, subject to the
additional limitations below. This warranty neither assumes nor authorizes any person to assume obligations other
than those expressly covered by this warranty.
NO CONSEQUENTIAL DAMAGES. TURBO AIR IS NOT RESPONSIBLE FOR ECONOMIC LOSS; PROFIT
LOSS; OR SPECIAL, INDIRECT, OR CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION,
LOSSES, OR DAMAGES ARISING FROM FOOD OR PRODUCT SPOILAGE CLAIMS WHETHER OR NOT
BECAUSE of REFRIGERATION FAILURE.
WARRANTY IS NOT TRANSFERABLE. This warranty is not assignable and applies only in favor of the original
purchaser / user to whom delivered. ANY SUCH ASSIGNMENT OR TRANSFER SHALL VOID THE WARRANTIES
HEREIN MADE AND SHALL VOID ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
IMPROPER USAGE. TURBO AIR ASSUMES NO LIABILITY FOR PARTS OR LABOR COVERAGE FOR
COMPONENT FAILURE OR OTHER DAMAGES RESULTING FROM IMPROPER USAGE OR INSTALLATION
OR FAILURE TO CLEAN AND / OR MAINTAIN PRODUCT AS SET FORTH IN THE WARRANTY PACKET
PROVIDED WITH THE UNIT.
ALTERATION, NEGLECT, ABUSE, MISUSE, ACCIDENT, DAMAGE DURING TRANSIT OR INSTALLATION,
FIRE, FLOOD, ACTS OF GOD. Turbo Air is not responsible for the repair or replacement of any parts that Turbo Air
determines have been subjected after the date of manufacture to alteration, neglect, abuse, misuse, accident,
damage during transit or installation, fire, flood, or act of God.
IMPROPER ELECTRICAL CONNECTIONS. TURBO AIR IS NOT RESPONSIBLE FOR THE REPAIR OR
REPLACEMENT OF FAILED OR DAMAGED COMPONENTS RESULTING FROM ELECTRICAL POWER
FAILURE, THE USE OF EXTENSION CORDS, LOW VOLTAGE, OR VOLTAGE DROPS TO THE UNIT.
NO IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE: THERE
ARE NO OTHER WARRANTIES, EXPRESSED, IMPLIED OR STATUTORY, EXCEPT THE ONE (1) YEAR
PARTS & LABOR WARRANTY AND THE ADDITIONAL FOUR (4) YEAR COMPRESSOR WARRANTY AS
DESCRIBED ABOVE. THESE WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES,
INCLUDING IMPLIED WARRANTY AND MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
THERE ARE NO WARRANTIES, WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF.
OUTSIDE U.S. AND CANADA: This warranty does not apply to, and Turbo Air is not responsible for, any warranty
claims made on products sold or used outside the United State and Canada.
CHANGES MADE TO WARRANTY COMMENCED ON 5/1/2002
Page 11
11
Master bilt
908 Highway 15 North • New Albany, MS 38652
Phone: (662)534-9061•Toll-Free: 800-647-1284
FAX: (662)534-6049•Toll-Free: 800-232-3966
www.master-bilt.com
Loading...