Master MST-3000 Instruction Manual

1

ZEUS TECH CO.LTD, SHEN ZHEN, CHINA

MST-3000

Motorcycle Diagnostic

Instruction

2

ZEUS TECH CO.LTD, SHEN ZHEN, CHINA

Part 1 Scanner Introduction & Attentions

 Scanner appearance and keys:

Signal Light

5.6’color LCD

Keypad

Power light

Top view:

SD card socket

12V power supply socket

Diag. interface socket

USB to RS232 interface

3

ZEUS TECH CO.LTD, SHEN ZHEN, CHINA



Diag. accessories:

4

ZEUS TECH CO.LTD, SHEN ZHEN, CHINA

5

ZEUS TECH CO.LTD, SHEN ZHEN, CHINA

※Please connect the power cable to the scanner’s 12V socket when diagnosis with YAMAHA
models.
※Please connect the power cable to the scanner’s 12V socket when diagnosis with HONDA
models.

Buttons descriptions

▲▼ Up down Arrow Keys：Choose items
◄ ►Left right arrow keys：Shift pages
Enter：Perform
Esc：Return
F1,F2,F3,F4 Function keys：Reserved

6

ZEUS TECH CO.LTD, SHEN ZHEN, CHINA

Attentions

Use restrictions

1. The displays screen and illustrations (such as key markings) in this manual are for illustrative

purpose only, and may differ somewhat from the actual items they represent.

2. The contents of this manual are subject to change without notice.

3. In no event shall Shenzhen Zeus Technology Co., LTD be liable to anyone for special, collateral,

incidental, or consequential damages in connection with or arising out of the purchase or use of these
materials.

4. Shall Shenzhen Zeus Technology Co.,LTD not be liable for any claim of any kind whatsoever against

the use of these materials by any other party.

5. Avoid use and storage in areas subjected to temperature extremes. Very low temperatures can cause

slow display response, total failure of the display. Also avoid leaving the scanner in direct sunlight,
near anywhere else it might be exposed to very high temperatures. Heat can cause discoloration or
deformation of the scanner's case, and damage to internal circuitry.

6. Never attempt to disassemble the scanner or tamper with the connection settings without permission.

7. Never press the keys of the scanner with a ballpoint pen or other pointed object.

8. Use a soft, dry cloth to clean the exterior of the scanner. If the scanner becomes very dirty, wipe it off

with a cloth moistened in a weak solution of water and a mild neutral household detergent. Wring out
all excess moisture before wiping the scanner. Never use thinner, benzene or other volatile agents to
clean the scanner. Doing so can remove printed markings and can damage the case.

9. Working conditions:

Temperature：0～60℃；Humidity: relative humidity below 80%.

10. Don't connect to diagnostic test sync when examine the ignition system sparking voltage Test, or
high-pressure disturbance may result in equipment damage

Checking when use

1． Check whether the ignition is on.

2． Check the whether the scanner's power light is on (red light), when testing the system whether the

signal light is flash.

3． check the diagnostic cable and the interface whether is bad contact or short-circuit.

4．Check whether the software version is applicable to the vehicle types