Massive Audio BP200.2, BP1000.2, BP1500.2, BP800.4, BP1000.4 User Manual

BLADE(BP) Series Amplifiers

BP
BP
BP
BP
BP
BP

BP
BP
BP
BP
BP
BP

1

BLADE(BP)

BLADE(BP)

1 Ohm Stable Design (Mono Amps-BP1200.1, BP2000.1)

2

2 Ohm Stable Design (Full Range Mono Amps-BP600.1,
BP1000.1, BP4000.1, BP6000.1)

3

is 9V to 200mv(250mV). This is NOT a volume control!

4

18. Dual Internal Cooling Fans(BP4000.1,BP6000.1)

16. NO Indicator
Indicator the amplifier is grounded, and receiving +12V and REM power.

17. CLIP Indic

ator(BP4000.1,BP6000.1)

This LED indicates when clipping is present while playing source material. If the
CLIP LED is flashing it also indicates the clip limiter is engaging. At this point it is
suggested to adjust the amplifiers gain level until the CLIP LED is only flashing on
peak bass notes. The clip limiter protection can be overdriven resulting in possible
damage to your speakers and/or the amplifier.

When the device is running, the f

an starts to run a

t a speed of 3500 per second

when the device surf

ace temperature reaches 50 degrees. If the device temperature
reaches 80 degrees, inside of the thermal protection starts automatically, the device
will stop working. But, the fan will still keep the same running speed for the device
cooling.

5

BP600.1/BP1000.1

Fig 2. Mono amplifier panel layout

BP

BP500.2/BP1000.2/BP1500.2

Fig 1. 2-ch amplifier panel layout