BLADE(BP) Series Amplifiers
BP
BP
BP
BP
BP
BP
BP
BP
BP
BP
BP
BP
1
BLADE(BP)
BLADE(BP)
1 Ohm Stable Design (Mono Amps-BP1200.1, BP2000.1)
2
2 Ohm Stable Design (Full Range Mono Amps-BP600.1,
BP1000.1, BP4000.1, BP6000.1)
3
is 9V to 200mv(250mV). This is NOT a volume control!
4
18. Dual Internal Cooling Fans(BP4000.1,BP6000.1)
16. NO Indicator
Indicator the amplifier is grounded, and receiving +12V and REM power.
17. CLIP Indic
ator(BP4000.1,BP6000.1)
This LED indicates when clipping is present while playing source material. If the
CLIP LED is flashing it also indicates the clip limiter is engaging. At this point it is
suggested to adjust the amplifiers gain level until the CLIP LED is only flashing on
peak bass notes. The clip limiter protection can be overdriven resulting in possible
damage to your speakers and/or the amplifier.
When the device is running, the f
an starts to run a
t a speed of 3500 per second
when the device surf
ace temperature reaches 50 degrees. If the device temperature
reaches 80 degrees, inside of the thermal protection starts automatically, the device
will stop working. But, the fan will still keep the same running speed for the device
cooling.
5
BP600.1/BP1000.1
Fig 2. Mono amplifier panel layout
BP
BP500.2/BP1000.2/BP1500.2
Fig 1. 2-ch amplifier panel layout
Fig 2. Mono amplifier panel layout
BP1200.1/BP2000.1
BP4000.1/BP6000.1
50Hz
HPF
20 16KHz
LPF
50
BANDPASS
LEVEL
750Hz
BOOST FREQ
50
BASS
0DB 12DB
0.25V9V
BP
REMOTE
GAIN
2 MINIMUM
6
7
Fig 3. 4-CH amplifier panel layout
BP
BP800.4/BP1000.4
Fig 4. 5-ch amplifier panel layout
BP1500.5
Fig 5. Mono amplifier Wiring
BP1200.1/BP2000.1
BP600.1/BP1000.1
2 OHM MINIMUM
1 OHM MINIMUM
BP
8
4 OHM MINIMUM
2 OHM MINIMUM
Fig 6. Mono Amplifier Wiring
BP1200.1/BP2000.1
BP600.1/BP1000.1
BP
9
*Subwoofer loads cannot be less than the minimum stable impedance rated
in this manual.
The two negative and positive speaker terminanls are wired internally.
Only one neagative and one positive terminalis required when wiring to bp
mono amplifiers.
10
Fig 7. Mono amplifier Wiring
BP4000.1/BP6000.1
50Hz
HPF
20 16KHz
LPF
50
BANDPASS
LEVEL
750Hz
BOOST FREQ
50
BASS
0DB 12DB
0.25V9V
BP
REMOTE
GAIN
2 OHM MINIMUM
2 MINIMUM
4 OHM
Fig 8. BP500.2/1000.2/1500.2 Amplifier Wiring
(1-CHANNEL MODE)
4 OHM 4 OHM
Fig 9. BP500.2/1000.2/1500.2 Amplifier Wiring
(2-CHANNEL MODE)
11
Fig 10. BP800.4/1000.4 Amplifier Wiring
(3-CHANNEL MODE)
2OHM-4 OHM 2OHM-4 OHM
BP
Fig 11. BP800.4/1000.4 Amplifier Wiring
(4-CHANNEL MODE)
2OHM-4 OHM 2OHM-4 OHM
2OHM-4 OHM 2OHM-4 OHM
BP
12
4 OHM TO 8OHM 4 OHM TO 8OHM
Fig 12. BP1500.5 Amplifier Wiring
(4-CHANNEL MODE)
2OHM-4 OHM 2OHM-4 OHM
2OHM-4 OHM 2OHM-4 OHM 2OHM-4 OHM
2OHM-4 OHM
13
14
35A x 2 25A x 2
320x51x180
12.6x2.0x7.1
0-6dB/12dB@45Hz0-6dB/12dB@45Hz
30A x 2
BP1000.4
Full-3KHz
320x51x180
12.6x2.0x7.1
80Hz-3KHz
45A x 1
0-6dB/12dB@45Hz
BP1000.2
Full-3KHzFull-3KHz
240x51x180
9.4x2.0x7.1
250W X 2
80W X 2
160W X 2
500W X 2
160W X 2
240W X 2
320W X 1 640W X 1
15Hz-30KHz 15Hz-30KHz
50Hz-260Hz 50Hz-260Hz
>90dB >90dB
20Hz-50Hz 20Hz-50Hz
<0.10% <0.10%
0-6dB/12dB@45Hz
Full-3KHz Full-3KHz
750W X 2
240W X 2
480W X 2
960W X 1
200W X 4
60W X 4
120W X 4
600W X 1
150W X 1
300W X 1
1200W X 1
600W X 1
300W X 1
500W X 1
2000W X 1 4000W X 1 6000W X 1
1000W X 1 1500W X 1
2000W X 1 3000W X 1
1000W X 1
500W X 1
900W X 1
240W X 2
15Hz-30KHz 15Hz-30KHz 15Hz-30KHz10Hz-35KHz 15Hz-250Hz 15Hz-250Hz 20Hz-16KHz 20Hz-16KHz
0.25~9.0V 0.25~9.0V
50Hz-260Hz 80Hz-3KHz
>90dB >95dB >95dB >60dB >60dB
<0.10% <0.10% <0.10% <0.10% <0.10% <2.5% <2.5%<0.10% <0.05%
BP1500.2 BP800.4
PEAK OUTPUT POWER@14.4V
CHANNELS
BP500.2
25A x 1
0-6db/12dB@45Hz
200X51X180
7.9X2.0X7.1 11.8X2.0X7.1
300X51X180
15A x 2
0-6db/12dB@45Hz
11.0X2.0X7.1
280X51X180
BP600.1
50Hz-750Hz
25A x 2
0-6db/12dB@45Hz
11.8X2.0X7.1
300X51X180
BP1000.1
50Hz-750Hz
25A x 2
0-6db/12dB@45Hz
12.6X2.0X7.1
320X51X180
BP1200.1
80Hz-250Hz
40A x 2
External
(150A)
External
(250A)
0-6db/12dB@45Hz
13.4X2.0X7.1
340X51X180
BP2000.1 BP4000.1 BP6000.1
80Hz-250Hz 50Hz-16KHz
20Hz-50Hz 20Hz-50Hz
50Hz-16KHz
15Hz-55Hz
N/A+N/A
15Hz-30KHz
<0.10%
15.0X2.0X7.1
380X51X180
20hm Stereo
+2Ohm Mono
320Wx2+200Wx1
160Wx4+500Wx1
250Wx4+500W
80Wx4+200Wx1
25A x 3
BP1500.5
50Hz-3KHz(CH3&4)
80Hz-150Hz(CH5)
10Hz-300Hz(CH1&2)
10Hz-500Hz(CH3&4)
1 0hm Mono 2 0hm Mono 2 0hm Mono1 0hm Mono2 0hm Mono2 0hm Mono2 0hm Stereo2 0hm Stereo2 0hm Stereo2 0hm Stereo2 0hm Stereo
0-12dB@
(50Hz-750Hz)
0-12dB@
(50Hz-750Hz)
9.9X2.2X7.5
251X55X190
12.6X2.2X7.5
321X55X190
15
16
Loading...