Marvel Refrigeration MLBV024 Operator’s Manual
Installation
Operation and
Maintenance
Instructions
Beverage Center
MLBV024-SG01A
Installation Operation and Maintenance Instructions
Installation Operation and Maintenance Instructions
Contents
Intro
Safety
Safety and Warning
Disposal and Recycling
Installation
Environmental Requirements
Electrical
Cutout Dimensions
Product Dimensions
Water Hookup
General Installation
Overlay Panel Dimensions
Overlay Panel Installation
Grille Installation
Door Swing
Door Adjust
Operating Instructions
First Use
Ice
Airflow and Product Loading
Maintenance
Cleaning
Cleaning Condenser
Extended Non-Use
Service
Troubleshooting
Warranty
Obtaining Service
2
Installation Operation and Maintenance Instructions
Welcome to the Marvel Experience
Congratulations on adding a new Marvel Built-in Undercounter Beverage Cooler
to your home and thank you for choosing our quality American-built product. We
are thrilled to welcome you to our growing community of Marvel owners, who
trust in our products and our support.
The information in this guide is intended to help you install and maintain your
new Marvel Beverage Cooler to protect and prolong the lifetime of your unit. We
encourage you to contact our Technical Support team at (800) 223-3900 with any
questions.
Cheers!
Installation Operation and Maintenance Instructions
3
Installation Operation and Maintenance Instructions
Disposal and Recycling
DANGER
!
RISK OF CHILD ENTRAPMENT. Before you throw away
your old refrigerator or freezer, take off the doors and
leave shelves in place so children may not easily climb
inside.
If the unit is being removed from service for disposal, check
and obey all federal, state, and local regulations regarding the
disposal and recycling of refrigeration appliances, and follow
these steps completely:
1. Remove all consumable contents from the unit.
2. Unplug the electrical cord from its socket.
3. Remove the door(s)/drawer(s).
Safety and Warning
NOTICE
Please read all instructions before installing, operating, or
servicing the appliance.
CAUTION
!
Caution means that failure to follow this safety statement
may result in minor or moderate personal injury, property,
or equipment damage.
DANGER
!
This unit contains R600a (Isobutane) which is a
ammable hydrocarbon. It is safe for regular
use. Do not use sharp objects to expedite
defrosting. Do not service without consulting the
“R600a specications” section included in the
User Guide. Do not damage the refrigerant
circuit.
WARNING
!
Service must be done by factory authorized
service personnel. Any parts shall be replaced
with like components. Failure to comply could
increase the risk of possible ignition due to
incorrect parts or improper service.
Use this appliance for its intended purpose only and follow
these general precautions with those listed throughout this
guide:
SAFETY ALERT DEFINITIONS
Throughout this guide are safety items labeled with a Danger,
Warning, or Caution based on the risk type:
DANGER
!
Danger means that failure to follow this safety statement
will result in severe personal injury or death.
WARNING
!
Warning means that failure to follow this safety statement
could result in serious personal injury or death.
CALIFORNIA PROPOSITION 65
This product contains chemicals known to the state of
California to cause cancer and birth defects or other
reproductive harm.
www.P65warnings.CA.gov
4
Installation Operation and Maintenance Instructions
Environmental Requirements
This unit is designed to operate between 50°F (10°C) and
100°F (38°C). Higher ambient temperatures may reduce the
unit’s ability to reach low temperatures and/or reduce ice
production on applicable models.
For best performance, keep the unit out of direct sunlight and
away from heat generating equipment.
In climates where high humidity and dew points are present,
condensation may appear on outside surfaces. This is
considered normal. The condensation will evaporate when the
humidity drops.
CAUTION
!
Damages caused by ambient temperatures of 40°F (4°C) or
below are not covered by the warranty.
The unit requires a grounded and polarized 115 VAC, 60
Hz, 15A power supply (normal household current). An
individual, properly grounded branch circuit or circuit breaker
is recommended. A GFCI (ground fault circuit interrupter) is
usually not required for xed location appliances and is not
recommended for your unit because it could be prone to
nuisance tripping. However, be sure to consult your local codes.
See CUTOUT & PRODUCT DIMENSIONS for recommended
receptacle location.
Electrical
WARNING
!
SHOCK HAZARD — Electrical Grounding Required. Never
attempt to repair or perform maintenance on the unit until
the electricity has been disconnected.
Never remove the round grounding prong from the plug
and never use a two-prong grounding adapter.
Altering, cutting or removing power cord, removing power
plug, or direct wiring can cause serious injury, re, loss of
property and/or life, and will void the warranty.
Never use an extension cord to connect power to the unit.
Always keep your working area dry.
NOTICE
Electrical installation must observe all state and local
codes. This unit requires connection to a grounded (three-
prong), polarized receptacle that has been placed by a
qualied electrician.
5
Installation Operation and Maintenance Instructions
1
”
(25 mm)
23 ⁄”
(608 mm)
3 ⁄”
(91 mm)
34 ⁄” to 35 ⁄”
(867 mm
to
892 mm)
28”
(711 mm)
1 ⁄”
(48mm)
20 ½”
(521 mm)
24 ½”
(622mm)
20 ⁄”
(530 mm)
4"
(102 mm)
7"
(178 mm)
24"
(610 mm)
24 1⁄4"
(616 mm)
34 1⁄8"
(867 mm)
to
35 1⁄8"
(892 mm)
Preferred location
for electrical outlet
is in adjacent
cabinet.
5/8"
(16 mm)
Power Cord
6 ft (183 cm)
6 ⁄”
(162 mm)
3 ⁄”
(98 mm)
Cutout & Product Dimensions
PREPARE SITE
Your product has been designed for either free-standing or
built-in installation. When built-in, your unit does not require
additional air space for top, sides, or rear. However, the front
grille must NOT be obstructed, and clearance is required for an
electrical connection in the rear.
CAUTION
!
Unit can NOT be installed behind a closed cabinet door.
CUTOUT DIMENSIONS
FRONT
TOP
*24” cutout width sufcient if door protrudes beyond adjacent
cabinetry
PRODUCT DIMENSIONS
REAR
SIDE
6
26 ¾”
(680 mm)
24 ⁄”
(613 mm)
(333 mm)
13 ⁄”
18 ⁄”
(467 mm)
22 ½”
(572 mm)
22 ⁄”
(562 mm)
Loading...