Martin Universal Design U-DS90W User Manual

U-DS90W Creation Station

Drawer Assembly Instructions

A B C D

Top - 1 Piece Inside Section - 3 Pieces Drawers - 3 PiecesBottom - 1 Piece

Assemble your drawers by
taking the bottom piece [C]
and snapping into place ­by lining up the tabs with the
grooves in the outside edge
of each sectional piece [B].
Repeat with all [3] section
pieces [B]. Complete Drawer
bank by snapping into place
the Top piece [A] into the top
section of part [B].
Finish by sliding the
[3] Drawers into the
drawer bank assembly.

Drawer Parts & Quantity

A

B

B

After proper assembly the
drawers should look like the
above illustration.

B

C

D

IMPORTANT

If you have difficulty assembling your U-DS90W Drawers or need customer service assistance.

Please call: Martin Universal Design, Inc. Customer Service Hot Line at 1-313-895-0700.

If you need additional parts, it is not necessary to contact your dealer,

our Customer Service Rep. will forward them to you immediately.

4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:[phone]/Fax:[phone]
Email: [e-mail] • visit us at www.MartinUniversalDesign.com

Revised June 07- RPI