Martin Universal Design U-DS31W User Manual

U-DS31W Drawing Table

Assembly Instructions

Carton Contents:

Table Base

[2] Base Feet

Hardware Pack

4444 Lawton Ave., Detroit, MI 48208 USA
Tel: [phone] • Fax: [phone]
E-mail: [e-mail]

Hardware Pack Contents:

[4] Screws

[2] Allen-Screws

[1]

Allen-

[2] Washers

Wrench

Pg. 1

created 08/27/06 RPI

U-DS31W Drawing Table Assembly Instructions

Open carton and remove all contents. Check to make sure carton contains:

A. [1] Folded Drawing Table B. [1] Hardware Pack (taped to the drawing table) C. [2] Base-Feet

STEP 1. Begin by taking folded drawing table out of

carton. See image below.

Hardware pack

STEP 2. Remove the hardware pack which is
taped to the drawing table base. Remove the [2]
base feet from the carton. Set aside.

STEP 4. Table should now look like image below.
Base-feet now attached.

STEP 5. Loosen Large Black knobs on table base
to allow height adjustments

STEP 3. Attach Base-feet to table by using [1]
washer and [1] Allen-screw. Repeat with other
base-foot.

Allen-Screw

Washer

4444 Lawton Ave., Detroit, MI 48208 USA
Tel: [phone] • Fax: [phone] • E-mail: [e-mail]

STEP 6. Loosen Lever on table base to allow for
tilt adjustments.

Pg. 2

created 08/27/06 RPI

U-DS31W Drawing Table Assembly Instructions

STEP 7. Loosen screws beneath the “H” arms to
allow the metal arms to be extended for top
attachment. Repeat with other side.

Screwdriver

STEP 8. Once arms are extended to proper length
for top, secure by tightening the screws you
loosened in STEP 7.

STEP 9. Carefully place Table Top onto base and
adjust extension arms where needed, so that the
ends are flush with the top. Secure with [4] wood
screws into the specified locations shown below.

Wood Screw location

Wood Screw

location

Wood Screw location

Wood Screw

location

Extended arms to hold

Table Top

STEP 10. Double check all screws and bolts to
make sure everything is secure.

STEP 11.

Loosen Large Black knobs on table base
to allow height adjustments, then re-tighten to
secure Loosen Lever on table base to allow for tilt
adjustments, then re-tighten to secure.

STEP 12. Your NEW U-DS31W is now ready for
your enjoyment.

Pg. 3

4444 Lawton Ave., Detroit, MI 48208 USA
Tel: [phone] • Fax: [phone] • E-mail: [e-mail]

created 08/27/06 RPI