Martin Universal Design 91-1106 User Manual

IMPORTANT NOTICE

YOU WILL FEEL A SLIGHT

“BOUNCE-BACK” WHEN YOU SIT DOWN.

THIS IS NORMAL: NOT A DEFECT.

THE PNEUMATIC CYLINDER FOR THE SEAT

HEIGHT ADJUSTMENT REACTS TO YOUR

WEIGHT BY GIVING A LITTLE

Parts

STILETTO

Model 91-1106

A. [1] Base Plate &

Lever

D. [1] 5-Star

Base

H. [1] Backrest

Cover

B. [1] Cylinder

[

E. [5] Push-in

Castors

C. [1] Backrest

Support Bar

Note: Part [J] is

attached to part [C]

I. [1] Foot Ring

Assembled 91-1106

F. [1] Backrest G. [1] Seat

Note: Part [L] 4 screws

are attached to part [G]

J. [1] Knob

Note: This knob is

attached to Part [C]

K. [4] 3/4” Black Screws

Note: These screws are

attached to Part [G]

IMPORTANT

If you have difficulty assembling your chair or need customer service assis

tance. Please call: Martin Universal Design, Inc. Customer Service Hot Line at

1-313-895-0700. If you need additional parts, it is not necessary to contact your

dealer, our Customer Service Rep. will forward them to you immediately.

L. [2] 1” Black Screws

-

4444 Lawton Avenue, Detroit MI 48208 USA

Tel:[phone] • Fax:[phone]

E-mail: [e-mail]

Visit us at:

www.MartinUniversalDesign.com

Created by RPI 0606

1.

I

2.

3.

K

B

D

E

Place base (D) face down and push
castors (E) in firmly. Insert cylinder
(B) through base cap into chair base.
Twist and press firmly.
Slide Foot Ring (I) down over cylinder.

A

J

C

Attach support bar with bellows (C) to
seat plate (A) by sliding the bar into the
raised area of the seat plate
(see arrow for location).
Thread Knob (J) into hole in seat plate,
making sure knob threads through seat
plate.

A

G

With seat cushion lying plastic side up,
line up holes in seat plate (A) with holes
in seat cushion (G). Attach with [4] 3/4”
black screws (K). Tighten securely.

4.

B

Take the complete seat assembly and
insert the seat plate over the cylinder
(B) by inserting the cylinder into the hole
on the bottom of the seat plate (A).

5.

Attach backrest (F) to backrest support
bar by snapping backrest cover (H) over
“T” of Support bar. Continue by attach­ing to backrest using [2] 1” black screws
(L). Tighten securely.

Chair is now ready to be used.

F

L

H

6.

Once complete, Double check all
screws and bolts to make certain
nothing is loose.
Chair is now ready to be used.

Created by RPI 0606