G A L L E R Y
RUSH Strobe CWL
This bright and compact LED linear strobe utilises 99 x 3 W Cree XP-
D
LEDs with a reflector design that offers a traditional Xenon strobe
look with a 17,000 lumen output. From a single flash to a blinder
effect, the RUSH™ Strobe CWL is the perfect companion for mobile
DJs, lounge bars, venues and cruise ships.
99 x Cree XP-D 3 W cold white LEDs
Reflector design
1
-25 FPS and blinder effect
F E A T U R E S
T E CHNI CA L S P E CI F I CA T I O NS
Physical
Dynamic Effects
Control and Programming
Optics
Construction
Installation
Connections
Electrical
•
Compact LED linear strobe
•
17,000 lumens output
•
Color system: 99 x cold white LED
•
87° beam angle
•
8 strobe macros
Length: 505 mm (19.9 in.)
Width: 140 mm (5.5 in.)
Height: 226 mm (8.9 in.)
Weight: 4.0 kg (8.9 lbs.)
Strobe rate: 0 - 25 Hz
Strobe duration: 0 - 10 ms (50 Hz supply), or 0 – 8.3 ms (60 Hz supply)
Blinder effect: Continuous with auto fade
Special effects: Ramp up/down, up-down, random flash, lightning, blinder, single flash
Control options: DMX, stand-alone, master/slave, sound trigger
DMX channels: 1 or 4
Setting and addressing: Control panel with LCD display
Compliance: USITT DMX512/1990
Beam angle: 87°
Light source: 99 x 3 W CREE white XB-D LED
Color temperature: 7000-8000 K
Minimum LED lifetime: 50 000 hours (to >70% luminous output)*
*Figure obtained under test conditions:
Color: Black
Housing: Steel and aluminum
Protection rating: IP 20
Mounting points: Bracket with 13.5 mm holes
Orientation: Any
Location: Indoor use only, must be fastened to surface or structure
Minimum distance to illuminated surfaces: 0.2 m (8 in.)
Minimum distance to combustible materials: 0.1 m (4 in.)
Minimum clearance around fans and vents: 0.1 m (4 in.)
AC power in/thru: Neutrik PowerCon
DMX data in/thru: 3-pin and 5-pin locking XLR
AC power: 100-240 V nominal, 50/60 Hz
Power supply unit: Diode bridge
©
2015 Martin Professional
Olof Palmes Allé 18 • 8200 Aarhus N • Denmark • Phone: +45 87 40 00 00 • Fax: +45 87 40 00 10 • www.martin.com
Images contained in this brochure have been converted to CMYK and are not necessarily representative of actual colors. Specifications are subject to change without notice
Typical Power and Current
Thermal
Approvals
Included Items
Accessories
Related Items
Ordering Information
110 V, 60 Hz: 2.5 A, 250 W, PF 0.9
230 V, 50 Hz: 2.7 A, 380 W, PF 0.6
Measurements made at nominal voltage. Allow for a deviation of +/-10%.:
PF = Power Factor:
Cooling: Forced air (temperature regulated, low noise)
Maximum ambient temperature (Ta max.): 40° C (104° F)
Minimum ambient temperature (Ta min): 0° C (32° F)
EU safety: EN 60598-2-17 (EN 605981-1)
EU EMC: EN 55015, EN55032, EN 55103-2, EN 61000-3-2, EN 61000-3-3, EN 61547
US safety: UL 1573
US EMC: 47 CFR Part 15 Class A
Canadian safety: CSA 22.2 No. 166
Australia/NZ: C-Tick N4241
EU version: 1.5 m (5 ft.) power cable without mains plug, mounting bracket
US version: 1.5 m (5 ft.) power cable with mains plug, mounting bracket
Power cables, 16 A, for connection to power in chains:
Power input cable, 14 AWG, UL, SJT, 1.5 mm2, H05VV-F, with PowerCon input
connector, 3 m (9.8 ft.): P/N 11541508
Power relay cable, 14 AWG, UL, SJT, 1.5 mm2, H05VV-F, with PowerCon connectors,
1.4 m (4.6 ft.): P/N 11541509
Power relay cable, 14 AWG, UL, SJT, 1.5 mm2, H05VV-F, with PowerCon connectors,
2.25 m (7.4 ft.): P/N 11541510
Power relay cable, 14 AWG, UL, SJT, 1.5 mm2, H05VV-F, with PowerCon connectors,
3.25 m (10.7 ft.): P/N 11541511
Power connectors:
Neutrik PowerCon NAC3FCA female connector for power in, cable mount, blue: P/N
05342804
Neutrik PowerCon NAC3FCB male connector for power out/thru, cable mount, light
grey: P/N 05342805
DMX link
DMX termination plug, 3-pin male XLR: P/N 91613017
Installation hardware:
Four-unit bracket for RUSH Strobe CWL: P/N 91606019
Half-coupler clamp: P/N 91602005
G-clamp: P/N 91602003
RUSH™ Software Uploader 1: P/N 91611399
RUSH™ Strobe CWL EU model in cardboard box: P/N 90480110
RUSH™ Strobe CWL US model in cardboard box: P/N 90480115
©
2015 Martin Professional
Olof Palmes Allé 18 • 8200 Aarhus N • Denmark • Phone: +45 87 40 00 00 • Fax: +45 87 40 00 10 • www.martin.com
Images contained in this brochure have been converted to CMYK and are not necessarily representative of actual colors. Specifications are subject to change without notice
Loading...