Martin Raptor User manual
Raptor
user manual
1 mounting
bracket
2 swivel lock
3 clamp hole
4 lamp access
screws
5 air vents
© 2001 - 2002 Martin Professional A/S, Denmark.
All rights reserved. No part of this manual may be
reproduced, in any form or by any means, without
permission in writing from Martin Professional A/S,
Denmark.
Printed in China.
P/N 35000089, Rev. D
I
NTRODUCTION
Thank you for selecting the Martin Raptor. This Martin lighting fixture uses
a 250 watt halogen lamp, parabolic reflector, effect wheel, 3-color
triangular prism, and built-in microphone to project multiple soundactivated beams of colored light.
The packing material is carefully designed to protect the fixture during
shipment - always use it to transport the fixture.
The Raptor comes with:
• 500 hour halogen lamp (installed)
• mounting bracket
• power cable
• user manual
SAFETY PRECAUTIONS
The Raptor is not for household use. It is not a toy: it presents risks of
serious injury due to electric shock, high heat, and intense light. For safe
operation, read this manual before using the fixture and observe all
warnings and precautions printed here and on the fixture. If you have
questions about how to operate the fixture safely, please contact your
Martin distributor or dealer.
1
• For protection against dangerous electric shock, the fixture must be
grounded (earthed). The AC mains supply shall be fitted with a fuse or
circuit breaker and ground-fault protection.
• Use only a source of AC power that complies with local building and
electrical codes.
• Replace the lamp if it becomes defective or worn out. Allow the fixture to
cool for 5 minutes before installing a new lamp.
• Keep all combustible materials (for example fabric, wood, paper) at least
30 cm (12 inches) away from the fixture. Keep flammable materials well
away from the fixture.
Introduction 3
• Provide a minimum clearance of 10 cm (4 inches) around the fan and air
vent.
• When suspending the fixture above ground level, verify that the structure
can hold at least 10 times the weight of all installed devices and secure
the fixture with an approved safety cable. Block access below the work
area whenever installing or removing the fixture.
• When carrying the fixture, lock the mounting bracket securely and do not
place a hand over or under the triangular prism.
• Do not expose the fixture to rain or moisture.
• Do not illuminate surfaces within 1 meter (39 inches) of the fixture.
• Do not operate the fixture if the ambient temperature exceeds 40° C (104°
F).
• Never place filters or other objects over the lens or mirrors.
• Refer all service to a qualified technician.
4 Raptor user manual
Loading...