Martin Mania EF2 User manual

Mania EF2

user manual

Measurements are expressed in millimeters.

290

142

312

Ø13

250

Printed in China.

P/N 35000150, Rev. A.

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Mania EF2 overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 AC power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Overhead mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Setting the trig mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

The gobo wheel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11

Focusing the Mania EF2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Basic service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Lamp maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Mains fuse . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18

Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19

INTRODUCTION

Thank you for selecting a Martin Mania EF2. The Mania EF2 is a preprogrammed, music-activated, DJ effect with a motorized rotating mirrored-reflector and a motorized rotating-wheel with 8 static gobos (gobos are outlines or masks placed in a light beam to create different patterns).

S A F E T Y I N F O R M A T I O N

Warning! This product is not for household use. It presents risks of lethal or severe injury due to fire and heat, electric shock, and falls.

Read this manual before powering or installing the fixture, follow the safety precautions listed below and observe all warnings in this manual and printed on the fixture. If you have questions about how to operate the fixture safely, please contact a Martin distributor for assistance. Refer any service operation not described in this manual to a qualified technician. Do not modify the fixture or install other than genuine Martin accessories and upgrade kits.

Refer servicing to qualified personnel.

Maximum ambient temperature Ta = 40°C(104°F).

See serial label for replacement fuse size and lamp type.

Suitable for mounting on normally flammable surfaces.

Do not look directly into the light.

Risk of fire, electrical shock and burns.

Use only in dry locations.

For indoors use only.

Do NOT block exhaust vents.

4	Mania EF2 user manual

Shields, lenses or ultraviolet screens shall be changed if they become visibly damaged to the extent that their effectiveness is impaired, for example, by cracks or deep scratches.

The lamp shall be changed if it becomes damaged or thermally deformed.

If the external power cord of this luminaire is damaged, it shall be replaced by a special cord exclusively available from your Martin dealer.

Avoiding electri c shocks

Warning	Always disconnect from mains power before replacing the
	lamp, fuses, or any part, and when not in use.

•Before operation ensure that factory setting of voltage and frequency match local power supply.

•Always ground (earth) the fixture electrically.

•Use only a source of AC power that complies with local building and electrical codes and has both overload and ground-fault protection.

•Do not expose the fixture to rain or moisture.

•Never operate the fixture with missing or damaged lenses and/or covers.

Protectin g yoursel f an d other s fro m burns an d fire

Warning	Hot lamp. The exterior of the fixture can become hot. Allow to
	cool for at least 20 minutes before handling or opening.

•Surface temperature under steady state condition = 100°C (212° F).

•Minimum distance to flammable material = 0.3 m (1 ft).

•Minimum distance to illuminated surface 1.0 m (3.3 ft).

•Never attempt to bypass the thermostatic switch or fuses. Always replace defective fuses with ones of the specified type and rating.

•Ensure that the air flow through vents is free and unobstructed.

•Provide a minimum clearance of 0.1 meters (4 inches) around air vents.

•Never place filters or other materials over the lens or in the optical path.

•The exterior of the fixture can become hot. Allow the fixture to cool for at least 20 minutes before handling.

•Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C (104° F).

•Do not stare directly into the light.

•Never operate the fixture without all lenses and covers installed: an unshielded lamp emits dangerous UV radiation that can cause burns and eye damage.

Introduction

Preventin g injurie s du e t o falls

•When suspending the fixture above ground level, verify that the structure can hold at least 10 times the weight of all installed devices.

•Verify that all external covers and rigging hardware are securely fastened and use an approved means of secondary attachment such as a safety cable.

•Block access below the work area whenever installing or removing the fixture.

U N P A C K I N G

The packing material is carefully designed to protect the fixture during shipment - always use it to transport the fixture.

The Mania EF2 comes with the following:

•3-wire IEC power cable

•User manual

M A N I A E F 2 O V E R V I E W

Mounting bracket

Swivel locks

Safety wire attachment

AC supply setting

Gobo-wheel rotation switch

Trigger mode switch

Fuse holder

Power on switch

Thumb screw (cover lock)

Mains socket

6	Mania EF2 user manual

INSTALLATION

	A C P O W E R

	Before operation ensure that factory setting of voltage and frequency
	match local power supply.
	Always ground (earth) the fixture electrically.
	Use only a source of AC power that complies with local building and
	electrical codes and has both overload and ground-fault protection.
Note:	If the external power cord of this luminaire is damaged, it
	shall be replaced by a special cord exclusively available from
	your Martin dealer.

Configurin g fo r loca l mains power

	The Mania EF2 has a switch-selectable power supply that can operate in
	the following voltage ranges at 50-60 Hz:
	• 115 - 120 volts (setting 115)
	• 220 - 240 volts (setting 230)
Warning	Do not operate the fixture on a power supply that falls outside
	of these ranges.
	Select the operating range using the red AC supply switch at the rear of
	the fixture.
	AC supply setting

Installation

+ 14 hidden pages