Martin Magnum Pro 2000 User Manual

Magnum Pro 2000

user’s guide

CONTENTS

INTRODUCTION ................................................. 9

INSTALLING THE MAGNUM PRO 2000 ................................ 4

OPERATING VIA THE REMOTE CONTROL UNIT ......................... 5

OPERATING VIA A 0-10 VOLT SOURCE ............................... 6

SLAVE OPERATION ............................................... 7

IMPORTANT NOTES ON OPERATION ................................. 7

TROUBLE SHOOTING ............................................. 7

REPLACING THE FUSE ............................................ 8

RESETTING THE THERMO-SWITCH .................................. 8

TECHNICAL SPECIFICATIONS ...................................... 10

INTRODUCTION

The Magnum Pro 2000 is a high performance micro-controller based smoke machine, which
features:

Specially designed heating element for long life and reliability.
High pressure pump.
Variable smoke output.
Remote control unit with auto-timer and memory function.
0-10 V control input.
Slave output allows an infinite number of Magnum Pro 2000 smoke machines to be
controlled via one remote control unit.
All control connections via standard XLR/XLR balanced microphone cables.

9.5 litres (2.5 gallons) internal tank.
Electronic and mechanical overheating protection with manual reset.
Mounting bracket and carrying handles.
Uses non-toxic Martin fog-fluid.

To ensure maximum benefit and safe operation of your Magnum Pro 2000, please read this
users guide before operating the machine.

3

INSTALLING THE MAGNUM PRO 2000

Your Magnum Pro 2000 package comes complete with the following items:

Magnum Pro 2000 smoke machine with remote control unit.
5 metre (16.5 ft) XLR/XLR cable for remote control unit.
Adaptor-cap (for fluid tank) with fluid filter.
Users guide.

IMPORTANT!

Before attempting any of the following ensure that the machine is

disconnected from any mains power.

Fitting the mains plug:

The Magnum Pro 2000 is delivered from the factory without a plug on the mains lead. You
will have to fit a suitable plug (one that fits your local wall outlet) before you can connect the
machine to the mains. The double isolated mains lead on the Magnum Pro 2000 contains
three wires. The brown wire should be connected to the LIVE pin, the blue wire to the
NEUTRAL pin, and the Yellow/Green wire to the EARTH pin (ground).

Fitting the fluid tank:

Place the fluid tank in the body of the Magnum Pro 2000 as shown in figure 1 on page 10,
and replace the screw cap by the tube adaptor-cap (with the fluid filter) ensuring that the
fluid filter reaches the bottom of the tank. Finally, locate the fluid tube that is mounted to the
fluid inlet on the machine and then connect the opposite end of this tube to the fluid outlet
of the tank (the adaptor cap).

IMPORTANT!

Use Martin fog fluid only. This fluid is manufactured specially for Martin smoke

machines. Using another fluid may clog the heating element or cause the machine

to spit hot liquid from the nozzle. Martin fog fluid is delivered in tanks exactly

fitting in the Magnum Pro 2000 smoke machine.

Placing:

The Magnum Pro 2000 may be placed on a flat surface or hanged up by means of its
mounting bracket. The bracket allows you to turn and/or tilt the machine to a desired
position.

WARNING!

Due to the extremely hot temperature of the smoke vapour, DO NOT install the

Magnum Pro 2000 closer than 1 metre (3.5 feet) from public contact.

4