Martel Electronics MECP, MECP10K Data sheet

Pneumatic and Hydraulic
Hand Pumps

Features:

• Generate both pressure and vacuum

• Generate –27 ”Hg to 100 or 600 PSI, model-

dependent

• Generate hydraulic pressure from 0 to 10,000 psi

• Completely isolated vernier prevents heat

transfer from hand

• Precision valve for bleed control

• Pneumatic pumps include user-friendly, fi eld

serviceable, and replaceable check valves

• Ergonomic design makes it easy to pump, even

at high pressure

MECP500
Pneumatic Pump Kit

(shown with optional BetaGauge PI
Digital Test Gauge)

Description:

The MECP Series of pneumatic and hydraulic
test pumps are high performance hand operated
pumps that allow the user to generate both
pressure and vacuum for precise testing of pressure
instrumentation including transmitters, pressure
switches, etc.

The pneumatic pumps allow pressures in excess of
100 or 500 PSI (model-dependent) to be generated
with just a few strokes of the pump. By changing
the switching valve to vacuum, a range of -27" Hg is
available.

The MECP10K Hydraulic Pressure Test Pump works
with a variety of hydraulic fl uids or even water to

MECP500
Pneumatic Pressure Test Pump

easily generate test pressures up to 10,000 PSI (700
Bar). It uses a unique fully adjustable stroke control
to allow for fast priming or fi lling of test systems, and
then switching as needed to a smaller stroke for easier
pumping at high pressure.

The output pressure of all pumps can be fi ne tuned
using the vernier control. A precision needle valve
allows controlled venting for exacting pressure
calibration requirements.

All pumps features NPT connections for ease of use.
See specifi cations for details.

In addition to the bare pump, all pump models are
offered in kit form with a hard sided carrying case
and a fl exible connection hose with appropriate
fi ttings.

Specifi cations (0 °C to +50 °C, unless otherwise noted)

Accuracy Model

Parameter MECP100 MECP500 MECP10K

Operating Pressure Range -12 to 100 PSI -12 to 600 PSI 0 to 10,000 PSI
Maximum Working Pressure 150 PSI 750 PSI 10,000 PSI
Connection 1,
1, 1/8” FNPT (side) 1, 1/8th “ FNPT Port (for use

with Press. Relief Valve Only)
Compatibility air air most hydraulic fl uids and oils

and water

1

/8” FNPT port 1, 1/4” FNPT (top) 2, 1/4” FNPT (top and side)

MECP100
Pneumatic Pressure Test Pump

MECP100 Pneumatic Pump Kit

(shown with optional BetaGauge 321
Pressure Calibrator)

MECP10K Hydraulic Pump Kit

(shown with optional BetaGauge PI Digital Test Gauge)

MECP10K
Hydraulic Pressure Test Pump

© Copyright 2007-2008 Martel Electronics Corporation
All trademarks are the property of their respective owners.
0804r1/OEMM

Martel Electronics Corporation

Londonderry, NH; Tel: [phone]

Email: [e-mail] Web: www.martelcalibrators.com