Marshall Electronics V-LCD4-PRO-LR User manual

Marshall

Selector Switch

Power On/Off

Power In 12VDC

BNC Inputs and

V-LCD4-PRO-L5

To operate unit, insert the power plug (Marshall V-

Contrast Color BrightnessTint

PS12-500) into the power jack (center pin is +12VDC)
located on the side of the monitor. Turn the unit on by
pushing the power button in. The unit is turned off by
depressing the power button. The unit is equipped with
NTSC/PAL auto recognition logic. Simply supply a
NTSC or PAL composite video signal to either of the
two video BNC connectors labeled ‘IN’. Select the
active BNC input by using the selector switch. Adjust
the picture by using the control knobs on the top of the
unit.

The V-LCD4-PRO-L5 is equipped with an active loop-
through circuit. This loop-through will only work

1/4” 20 mount

when power is supplied to the monitor The monitor also has a 1/4-20 mount located on the
bottom of the unit. This is useful when mounting the monitor on the top of a camera by using a
hot shoe mount (Marshall part# V-LCD-MT) or other mounting devices.

Part No. Display Input Color Picture Pitch Controls Back Supply Connectors Size

V-LCD4-PRO-L5

4” LCD

Active
Matrix

2 NTSC/PAL

Inputs with

Loopthrough

Full

Color

480H x

234V

0.171W x

0.264H

Power On/Off,
Color,Brightness
Tint, Contrast

300 nits

12 VDC,

500mA

Video BNC,

5.5mm DC
power jack

Outputs

5.51W x

3.62”H x

1.81”D