Marsh TDE110 User Manual

TD2100 Electric Gummed Tape Dispenser

Owner’s Manual

1

42900 Rev. 08-25-2015

A wall-socket must be close to the product and readily accessible.

The overall system is protected against overload by the branch circuit
protection in accordance with the current edition of the NEC or CEC

Table of Contents

Introduction ..................................................................................................................................... 3

Warranty Information: .................................................................................................................... 4

Specifications .................................................................................................................................. 5

Setup Instructions............................................................................................................................ 6

Operating Instructions ..................................................................................................................... 9

Maintenance .................................................................................................................................. 12

Troubleshooting ............................................................................................................................ 14

2

42900 Rev. 08-25-2015

Introduction

Congratulations on the purchase of your new MARSH TD2100 gummed tape dispenser from
MSSC, LLC. We are confident you will be very pleased with the operation and performance of
this durable, quality built machine for many years to come.

The TD2100 Electric Taper Technical Manual provides the necessary information about the
operation, maintenance, and repair of your new tape dispenser. However, MSSC does have a
policy of continual product improvement. So, MSSC reserves the right to modify the information
contained within the manual without prior notice.

The setup section was designed to simplify the setup of the machine and allow you to get the
machine up and running so that the machine can do what it is designed to do… dispense
gummed tape quietly, quickly and accurately.

The operating section provides information on the operation of the machine, i.e. keystroke
operation, programming repeat lengths, etc.

The maintenance section provides information about required care and maintenance of the
machines and further adjustments if required for your particular use.

This technical manual provides a troubleshooting and repair sections to help you with possible
operating problems and corrective actions. Should you require replacement parts, please refer to
the provided parts list and the corresponding exploded view drawings.

For assistance, or if you would like to obtain information about any Marsh product, contact your
Marsh distributor or MSSC, LLC at:

3

42900 Rev. 08-25-2015

Warranty Information:

MSSC, LLC warrants that your selling distributor will repair, replace, or adjust components
found to be defective in factory materials or workmanship for a period of 18 months. Your
Marsh distributor will provide free service for ninety (90) days from the beginning of the
warranty period. The warranty period begins on the original installation date as indicated on
your on-line warranty registration.

Conditions of warranty:

1. Properly regulated and grounded electrical power that is free of surges and spikes
must be provided for electrical equipment.

2. Operating personnel must be properly instructed on use of machine.

3. Maintenance procedures must be observed – see Owner’s Manual.

4. Use only approved Marsh accessories and replacement parts.

5. Warranty must be validated by Marsh MSSC, LLC. If no warranty is submitted,
coverage begins on the date of shipment from MSSC, LLC.

Exclusions: Damage due to tampering, abuse, improper adjustments, use of non-approved
components or electrical interference will not be covered by the warranty.

4

42900 Rev. 08-25-2015

Specifications

Net and Shipping Weight: 26 pounds (11.8 kg); 32 pounds (14.5 kg)

Water Bottle Capacity: 70 ounces (2070 ml)

Tape: Dry gummed tape – paper or reinforced – between 1 to 3 inches

(25.4 to 76.2 mm) wide, up to 1000 feet (304.8 m) long and 9
(228.6 mm) inches max roll diameter

Electrical Requirements: 115 volts AC or 220 volts AC

50/60 Hz
4 amps at 115 volts
2 amps at 220 volts

Power Cord Length: 7 feet (2.3 m)

Dimensions:

18.9 in.

48.0 cm

10.1 in.

25.5 cm

11.9 in.

30.1 cm

Figure 1 - Tape Machine Dimensions

5

42900 Rev. 08-25-2015