Mars 380117HP Users Manual

FCC Part 15.249 Certification

Test Report

FCC ID: SJS-380117HP

FCC Rule Part: 15.249

ACS Report Number: 07-0088-15C

Manufacturer: Mars Company

Model: 380117HP

Installation Guide

5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: [phone]

MARS SmartRadio Installation Guide

To ensure proper connection and resistance to water intrusion a
waterproof butt splice is required to connect the SmartRadio transmitter to
the meter register. The recommended type of connector is a Scotchlok™
connector. This type of connector is ideal because it provides a good
mechanical connection of the wires and a waterproofing gel that inhibits
water ingress.

This device is designed to be installed in a meter pit at or below ground
level. Professional installation by factory trained personnel is required for
proper use and reliable communication.

Meter Connection Table

Manufacturer Radio

Red

Sensus Encoder R Encoder G Encoder B

Radio

Green

Radio

Black

Hersey Encoder R Encoder G Encoder B
Neptune Encoder B Encoder R Encoder G
Amco/ABB Scancoder Encoder G Encoder R Encoder B
Amco InVision Encoder B Encoder R Encoder Shld
Severn Trent Terminal 1 Terminal 3 Terminal 5
Severn Trent - Generation 2 Encoder R Encoder G Encoder B

Installation Steps

1. Refer to the table above for wiring color codes.

2. While holding the Scotchlok™ connector with the button facing down,
insert un-stripped wires fully into connector.

3. Once seated, use a crimper and firmly squeeze the connector until
you hear a snap and gel seeps out of the end of the connector.

4. Repeat steps 1-3 for the other two pairs of wires and test to ensure
the SmartRF is transmitting properly.