Mars 380115WM Users Manual

FCC Part 15.249 Certification

Test Report

FCC ID: SJS-380115WM

FCC Rule Part: 15.249

ACS Report Number: 07-0089-15C

Manufacturer: Mars Company

Model: 380115WM

Installation Guide

5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: [phone]

MARS SmartTransmitter Installation Guide

To ensure proper connection and resistance to water intrusion a
waterproof butt splice is required to connect the SmartRadio transmitter to
the meter register. The recommended type of connector is a Scotchlok™
connector. This type of connector is ideal because it provides a good
mechanical connection of the wires and a waterproofing gel that inhibits
water ingress.

This device is designed to be installed at or above ground level either
indoors or outdoors. Professional installation by factory trained personnel
is required for proper use and reliable communication.

Meter Connection Table

Manufacturer Radio

Red

Sensus Encoder R Encoder G Encoder B

Radio

Green

Radio

Black

Hersey Encoder R Encoder G Encoder B
Neptune Encoder B Encoder R Encoder G
Amco/ABB Scancoder Encoder G Encoder R Encoder B
Amco InVision Encoder B Encoder R Encoder Shld
Severn Trent Terminal 1 Terminal 3 Terminal 5
Severn Trent - Generation 2 Encoder R Encoder G Encoder B

Installation Steps

1. Refer to the table above for wiring color codes.

2. While holding the Scotchlok™ connector with the button facing down,
insert un-stripped wires fully into connector.

3. Once seated, use a crimper and firmly squeeze the connector until
you hear a snap and gel seeps out of the end of the connector.

4. Repeat steps 1-3 for the other two pairs of wires and test to ensure
the SmartRF is transmitting properly.