REPLACEMENT PARTS
When ordering replacement parts for MARMONHERRINGTON ALL-WHEEL DRIVE conversions,
the following information should be given:
1.FACTORY ORDER NUMBER (found on I.D. Plate
on driver’s door panel or small plate affixed to axle
housing). This will be a six (6) digit number.
(See illustrations this page.)
2.Component for which parts are required, i.e. front
drive axle or transfer case.
3. Model of axle and/or transfer, i.e. MR-90, MR-226.
4.Give quantity and part number required.
NOTE: Drive lines, shift linkage, etc., can be found
on the computer print out of Bill of Material, which
is included in the Service Manual.
5.Give complete billing and shipping address.
WARRANTY CLAIM PROCEDURE
When ordering parts which you feel might be covered
under warranty, advise the following information:
1.FACTORY ORDER NUMBER (found on I.D. Plate
on driver’s door panel or small plate affixed to axle
housing). This will be a six (6) digit number.
(See illustrations this page.)
2.Date unit was put into operation.
3.Mileage of unit at time of failure.
4.Nature of failure.
Upon receipt of the above, you will be advised as to
how to proceed with the claim.
The information necessary for replacement
parts and/or warranty claim procedures will
be found on either plate design.
FACTORY
ORDER NO.
INSTALLED
BY
FRONT DRIVING AXLE
MODEL
CAPACITY
SERIAL NO.
RATIO
TRANSFER CASE
MODEL
SERIAL NO.
LOUISVILLE, KENTUCKY U.S.A.
PM01/02
MARMON-HERRINGTON
SALES ORDER
S/N
TYPE
RATIO
0000-00
0000-00
— 3 —