Page 1
Liberate XLBT
Noise-Isolating, Eco-Friendly Over-Ear Headphones
With Microphone and One-Button Controller
IB-EMFH041
Page 2
2 3
Liberate XLBT
Bluetooth® Over Ear Headphones
Greetings and Welcome to the House of Marley
We are honored you have selected Liberate XLBT to become part of your music experience. Liberate XLBT is a high
performance over-ear headphone with Bluetooth Functionality and one button control. The headphone has 50mm
drivers, rewind fabric headband and ear-cup, FSC wood logo treatment and protein leather ear cushions.
Everything You Need to Jam
The Liberate XLBT comes with the following items:
Liberate XLBT Headphones
Detachable 1 button-mic
cable (3.5mm)
micro USB charging
cable
Powering Your Liberate XLBT
Liberate XLBT includes a built-in rechargeable battery that is charged by the included micro
USB port. The LED by the power port will glow when the system is charging and turn off once
the battery is full.
Connecting Your Music Device(s)
Pairing Mode (Periodic Flashing Blue LED, every 5 seconds)
Liberate XLBT automatically goes into reconnect mode for 5 seconds as soon as you turn it on (flashing BLUE led).
It then switches to auxiliary mode (RED led). You can pair a new device to Liberate XLBT by
holding the for 3 seconds.
Note: Holding the
for 3 seconds will kick off the device currently connected to Liberate XLBT and go into
Pairin g Mode.
Connected Mode (Flashing Blue LED, every 5 seconds)
Use your Bluetooth-enabled device to pair to Liberate XLBT. Liberate XLBT does not require a pairing password.
Once paired, the LED will glow solid blue.
Note: Liberate XLBT will automatically pair with the last device connected to it when turned ON (when possible).
Charging Your Device
A convenient micro USB port is available on the right ear cup of the Liberate XLBT to charge
your devices while it is on or off. Use the cable that came with your device to charge.
NOTE: Not all devices are compatible with the micro USB port.
EN
Touch for volume control
Hold for volume ramping
Touch for BT connection (to last device)
Hold for pairing (or disconnect and pairing)
Touch to pause current track
Touch to play currently paused track
Touch to answer incoming call
Touch to end current call
Hold to turn “ON”
Press to check battery level
Hold to turn “OFF”
Touch for track change
Hold for fast forward/reverse
Page 3
4 5
Compatibility of Microphone and One-Button Control
Integrated microphone allows for hands free conversations. Push the button to answer a call; push it again to end
the call. Tracking and play/pause functions as shown on the illustration work with Apple devices only.*
x1 x1
x2
x3
Occupational Safety and Health Administration (OSHA) Guidelines for
Permissible Noise Levels and Exposure Durations.
Sound Pressure Level (SPL) Recommended Maximum Daily Exposure
90dB 8 Hours
92dB 6 Hours
95dB 4 Hours
100dB 2 Hours
105dB 1 Hour
110dB 30 Minutes
115dB 15 Minutes
Greater than 115dB Avoid SPL levels of 115dB and greater
Important Safety Information
1. Follow and keep these instructions.
2. Heed all warnings.
3. Do not use this apparatus near water.
4. Clean only with a dry cloth.
5. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
6. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that
produce heat.
7. Protect the power co rd from being walked on or pinched par ticularly at plug, convenience receptacles, and the point where
they exit from the apparatus.
8. Only use attachments/accessories specified by the manufacturer.
9. Unplug this apparatus during lightning storms or when unus ed for long periods of time.
10. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any
way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
11. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
WEEE EXPLANATION
This marking indicates that this product should not be disposed with other household wastes throughout the
EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your used device, please use
the return and collection systems or contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
BATTERY DIRECTIVE
This symbol indicates that batteries must not be disposed of in the domestic waste as they contain substances
which can be damaging to the environment and health. Please dispose of batteries in designated collection
points.
Responsible Listening
Be sure to turn the volume down on your music player before beginning to listen. This will eliminate the risk of
damaging your hearing with an excessive volume level. Never wear headphones while operating machinery, driving a car
or performing any other activity where hearing outside sounds is important. If you ever experience pain or discomfort
during or after listening to headphones you may be listening at an excessive volume level and causing permanent
hearing damage.
Support for other devices varies by model. All compatibility is subject to change.
EN
Page 4
1.3. IC Warning
RSS (Category I Equipment):
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada.
1.3. IC Warning
RSS (Category I Equipment):
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada.
IC Warning
RSS (Category I Equipment):
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada , le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé
pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et
son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse
pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.
IC SAR Warning
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment.
Cet appareil est conforme aux limites d'exposition aux rayonnements définies pour un
environnement non contrôlé.
Page 5
FCC Statement
FCC & IC Statement
FCC Caution
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to opera te the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
FCC Radiation Exposure Statement
IMPORTANT NOTE:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
1. FCC & IC Statement
1.1. FCC Caution
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
1.2. FCC Radiation Exposure Statement
IMPORTANT NOTE:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
FCC Caution
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to opera te the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
FCC Radiation Exposure Statement
IMPORTANT NOTE:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Loading...