Mark Feldstein Flameless LED Coach Lantern User Manual

COACH LED LANTERN
(A)
(B)
INSTRUCTIONS
1. Install 3 “AAA” batteries (not included) into the bottom battery compartment. Make sure that the battery polarity (+/-) is as indicated. (see A)
2. Use the On-Off-6H switch on the bottom of the lantern to turn LED to the OFF, ON or 6H (6 hour timer)* position. (see B)
3. If not set to 6H position, switch to OFF position when not in use.
*Built-In Automatic Timer Function. When switch is set to the 6H position, the LEDs will turn on for 6 hours and then automatically turn off for a period of 18 hours. If the timer function settings are not changed, the LEDs will automatically turn on and off at the same time each day.
BATTERY NOTICE Do not mix old and new batteries. Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel Cadmium) batteries. Replace all batteries at one time. To avoid leakage or explosion, do not put batteries in fire. Remove batteries if consumed or if product is to be left unused for a long period of time. Clean the battery contacts and also those of the devices prior to battery installation.
OFF
ON 6H
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with th e limits for a Class B digital device, pursuant to part 15 of the FCC Rules. T hese limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, w hich can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
Reorient or relocate the receiving antenna.Increase the separation betw equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced Radio TV technician for help.
Modifications not approved by the party responsible for compliance could void user’s authority to operate this unit.
een the
Maumee, Ohio 43537www.markfeldstein.com
6hr Timer Coach Lantern
Loading...